Dimplex BF8000ST 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Dimplex BF8000ST에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BF8000ST 17 페이지. 26” self trimming fireplace
Dimplex BF8000ST에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지), 서비스 매뉴얼 (16 페이지)

페이지 인쇄

Maintenance

Figure 6

Lower

Bulbs

Log Set

replacement will reduce the

number of times you need to

open the unit to replace light

bulbs.

To access the lower light bulb

area:

CAUTION: Allow at least five

minutes for the light bulbs to cool

before touching them to avoid

accidental burning of the skin.

1. Slide fireplace out of mantel.

2. Lay unit on it's back for safe

removal of front glass.

3. Remove four (4) Phillips

screws from the right side of

the trim.

4. Remove the trim.

5. Slide glass to right side of

fireplace to remove (Figure

6).

6. Pull the front edge of the

Upper

Bulbs

Trim

Front

Glass

Figure 7

Back

Ledge

Rear

Tab

Side Section

plastic Ember Bed or plastic

grate up and forward until the

rear tab releases from the

ledge located at the bottom

of the partially reflective glass

(Figure 7).

IMPORTANT: Only handle

the Log Set by the Ember Bed.

NOTE: Log Set fits tightly

into firebox, some force may be

necessary to remove.

7. Set Log Set in front of

fireplace.

8. Remove flicker rod by sliding

flicker rod to the left away

from the flicker motor and

lifting out.

1. Remove light bracket for

easier access to light bulbs.

9. Unscrew bulbs counter

clockwise.

10. Insert new bulbs.

Log

Ember Bed

Front

Edge