Dimplex BF8000ST 서비스 매뉴얼 - 페이지 4

{카테고리_이름} Dimplex BF8000ST에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BF8000ST 16 페이지. 26” self trimming fireplace
Dimplex BF8000ST에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (17 페이지)

페이지 인쇄

Battery Replacement (Figure 3)

To replace battery:

Slide battery cover open on the remote control.

Install one 12-volt (A23) battery in the battery holder.

Close the battery cover.

Battery must be recycled or disposed of properly.

Check with your Local Authority or Retailer for

recycling advice in your area.

Figure 3

Operation - No Remote

(MOD B-F Units)

To access the controls, flip open the control panel cover

towards the bottom of the fireplace (Figure 4).

Figure 4

A. On/Off Switch

The On/Off Switch supplies power to all fireplace functions.

B. Flame Speed Control

Turn the flame speed control knob to adjust the speed of

then flames to the desired level.

C. Interior Light Control

Turn the interior light control knob to increase or decrease

the brightness of the interior light.

D. Heater Thermostat Control

To adjust the temperature to your individual requirements,

turn the thermostat control clockwise all the way to turn on

the heater. When the room reaches the desired temperature,

turn the thermostat knob counter clockwise until you hear a

click. Leave in this position to maintain the room temperature

at its setting. For additional heat, turn clockwise until you

hear the click again and the heater will turn on. To turn the

heater off, rotate the knob fully counter clockwise.

E. Heat On/Off Switch

Turns heat on or off.

! NOTE: The heater may emit a slight, harmless odor

when first used. This odor is a normal condition caused

by initial heating of internal heater parts and will not occur

again.

Resetting The Temperature Cutoff Switch

This unit is equipped with a thermostat which controls the

temperature of the room. It does this by turning the heater

on and off. The heater is protected with a safety device

to prevent overheating. Should the heater overheat, an

automatic cut out will turn the heater off and it will not come

back on without being reset. It can be reset by switching

the On/Off Switch to Off and waiting five (5) minutes before

Battery

switching the unit back on.

CAUTION: If you need to continuously reset the heater,

unplug the unit and call Technical Support at

1-888-346-7539. Please have your model and serial

Battery

number ready when calling.

Cover