Dimplex BFSL33 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Dimplex BFSL33에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BFSL33 13 페이지. Fireplace
Dimplex BFSL33에 대해서도 마찬가지입니다: 소유자 매뉴얼 (14 페이지), 서비스 매뉴얼 (19 페이지), 설치 매뉴얼 (19 페이지)

페이지 인쇄

Operation

Figure 2

Button

Off

Button

Plastic

strip

Battery

cover

This remote control has a range

of approximately 50 feet (15.25

m), it does not have to be pointed

at the fireplace and can pass

through most obstacles (including

walls). It is supplied with one of

hundreds of independent frequen-

cies to prevent interference with

other units.

NOTE: Before attempting any

operation with the remote, pull

the plastic insulator strip out

from between the remote casing

and battery cover (Figure 2).

Remote Control Initialization/

Reprogramming

If the Remote Control or Re-

mote Control Receiver has been

replaced, follow these steps to

initialize the Remote Control and

Receiver:

1. Ensure that power is supplied

through main service panel.

2. Access the manual controls,

(remove the glass doors if

applicable) pull the right hand

steel curtain to the outside of

the unit.

3. Locate manual controls.

(Figure 1)

4. Set the 3-Position switch to

"Remote" (Figure 1D)

5. Activate the On/Off switch,

the red Level 1 Indicator Light

will flash. (Figure 1A)

6. Press and hold the On button

on the manual controls

(Figure 1B) for five seconds.

The Level 1 Indicator Light

(Figure 1E) will then flash for

10 seconds.

7. Within the 10 seconds press

the ON button located on the

remote control. (Figure 2)

This will synchronize the remote

control and receiver.

Battery Replacement

To replace the battery:

1. Slide battery cover open on

the remote control (Figure 2).

2. Install one (1) 12-Volt (A23)

battery in the battery holder.