Dimplex BLF34 서비스 매뉴얼 - 페이지 9

{카테고리_이름} Dimplex BLF34에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BLF34 16 페이지. Fireplace

페이지 인쇄

ing the screws to prevent the unit from falling.

3. Remove the fireplace out of the opening by slightly lift-

ing and pulling forward.

4. Carefully lay the unit down on a solid flat surface with

the front of the unit facing up.

NOTE: If the surface you are using as a work area is a

finished surface that is prone to scratches (i.e. hardwood

flooring), it is recommended that a protective barrier be

used underneath, (i.e. cloth, cardboard, thick plastic).

Figure 7

Mounting

holes

Figure 8

Wall Surface

Mounting Hole

Mounting hole

5. Proceed to the instructions within this manual relating

to the repair being performed - see Table of Contents

for page number.

6. Once repair is complete, reassemble in the reverse

order as above.

ON/OFF SWITCH REPLACEMENT

WARNING: Disconnect power before attempting any

maintenance or cleaning to reduce the risk of electric

shock or damage to persons.

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights and heating elements to cool

off to avoid accidental burning of skin.

Tools required: Phillips head screwdriver.

Needle nosed pliers.

CAUTION: Follow "Preparation for Service" instructions

before proceeding.

1. Remove the 2 screws, that secure the controls assem-

bly (Figure 9), located at the top of the mirror on the

right side of the unit.

2. Slide the controls assembly out toward the front of the

unit.

CAUTION: Ensure that the assembly is removed care-

fully, ensuring that no wires are caught or over strained.

Figure 9

Controls Assembly

Figure 10

LED

Driver Board

Remote

Receiver

Retaining Screws

On/Off

Switch

Board