ECKey EK6 series 설치 및 운영 매뉴얼 - 페이지 2
{카테고리_이름} ECKey EK6 series에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ECKey EK6 series 15 페이지. Internal/external mounting – red and green led control from access control system
ECKey EK6 series에 대해서도 마찬가지입니다: 설치 관리자 매뉴얼 (9 페이지)
페이지 인쇄1.
Installing ECKey Readers
a.
Record serial number and remove the screw holding the backplate to the reader housing.
b.
Run power and other wiring to reader location.
c.
Wire the reader according to table below and attach backplate to mounting surface with two screws through
the slots.
d.
Mount housing over backplate and replace screw.
• EK6 and EK7 readers have unique features. Carefully review the table below for correct wiring.
• ECKey readers are not weather-proof so use caution when choosing a mounting location.
• Make sure you have a back-up, like a key, in case power is lost to the reader or phone.
• Construction materials will affect read-range so test the phones before commissioning the system.
WIRE
* External blue light mimics the blue activity of ECKey Status Light
** If ECKey Admin Button is disabled, Secondary Admin Button is still enabled
*** ECKey Status Light color controlled by access control system
When properly powered, the reader should have a solid red status light. If the reader has a purple status light on
initial power up, simply remove and reapply power.
EK6
Red
Black
Tan
Green
Wiegand Data 0
White
Wiegand Data 1
Orange
Grey
Purple
Green Status Light Control ***
Pink
Yellow
N/A
Blue
N/A
Brown
N/A
ECKey Installation and Operation Guide
12-24V DC supply (+), 24VAC (+)
DC ground (-)
24 VAC (-)
External Blue Light *
Remote Admin Button **
Door/Gate Sensor
External Trigger
Relay Normally Closed
Relay Normally Open
2
EK7
N/A
N/A
Relay Common