Epson PowerLite 480 운영 매뉴얼 - 페이지 42

{카테고리_이름} Epson PowerLite 480에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson PowerLite 480 50 페이지. Maintenance
Epson PowerLite 480에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (4 페이지), 적합성 선언 (4 페이지), 빠른 설정 매뉴얼 (4 페이지), 사양 (6 페이지), 설치 핸드북 (4 페이지)

페이지 인쇄

Troubleshooting

Check

Are the access point and the projector's subnet different?

(Advanced Connection Mode only)

Have you enabled DHCP? (Advanced Connection Mode

only)

When a connection is made using EasyMP Network Projection, the projected image remains as it is, and a connection

cannot be made from another computer.

Check

Did the presenter leave the conference room without

cutting off the network connection?

Cannot select or change the connection mode.

Check

Is EasyMP Network Projection set to start up using the

same connection mode?

Select Manual search from EasyMP Network Projection, specify the IP address, and connect.

When DHCP is set to On in Advanced Connection Mode, it may take some time to enter LAN standby

status if an available DHCP server is not found.

With EasyMP Network Projection, the computer currently connected can be disconnected when

another computer tries to connect to the projector.

Therefore, when a Projector Keyword is not set for the projector, or if you know the Projector

Keyword, you can disconnect the computer currently connected and then connect your computer to

the projector.

When a Projector Keyword is set for the projector and you do not know the Projector Keyword, restart

the projector and reconnect.

Select Display Connection Mode Selection window on startup on the General settings tab from

Set options. The projector selection screen is displayed after restarting EasyMP Network Projection.

Remedy