Changing the Image's Aspect Ratio
If you're projecting a widescreen format image, you can use the
button on the remote control to change the aspect
Aspect
(width to height) ratio from
You can change video images to
(widescreen format), or
16:9
or
16:9 (Up)
16:9 (Down)
(to accommodate subtitles or
supertitles).
You can change computer
images to
(widescreen
16:9
format) or
.
Normal
Press the
button again
Aspect
to cycle through the available
options.
Note:
You can also change the aspect ratio using the projector's Signal
menu. See your User's Guide for details.
Projector Status Lights
The lights on top of the projector indicate the projector's status
and let you know when a problem occurs.
Power light
Lamp light
Temperature
light
If the projector is not working correctly, first turn it off and
unplug it. Then plug the power cord back in and turn on the
projector. If this does not solve the problem, check the status
lights on top of the projector and try the solutions
recommended in the following table.
.
4:3
Aspect
button
.
Power
Lamp
light
light
Green
Off
Flashing
Off
green
Orange
Off
Flashing
Off
orange
Red
Off
Red
Off
Red
Flashing
red
Orange
Flashing
orange
Red
Off
3/08
PowerLite 822p/83c Projector
Temp.
light
Description
Off
The projector is operating
normally.
Off
The projector is warming up.
Wait for the image to appear.
Off
The projector is in standby or
sleep mode. You can unplug it or
P
press the
Power button to
turn it on.
Off
The projector is shutting down.
Wait for the light to stop flashing
and remain orange before
unplugging it.
Flashing
The projector is too hot. Make
orange
sure the temperature
surrounding the projector does
°
not exceed 95
F (35
there is plenty of space around
and under the projector for
ventilation. Clean the air filter and
air vents, if necessary.
Red
The projector has overheated and
turned itself off. Let it cool for
about five minutes, then turn it
back on. Make sure there is
plenty of space around and under
the projector for ventilation. If
you are using the projector at an
altitude above 4921 ft (1500 m),
turn on High Altitude Mode as
the Operation setting in the
Extended menu. Also clean the
air filter and air vents. If it
continues to overheat, you may
need to replace the air filter.
Off
The lamp is burned out, broken,
or not installed correctly; or the
lamp cover is open. Close the
cover or replace or reseat the
lamp, if necessary. Also clean the
air filter and air vents. If these
suggestions don't work, contact
Epson.
Off
Replace the lamp with a new one
as soon as possible. If you
continue to use the lamp, there is
a risk it may break.
Flashing
There is a problem with the fan
red
or a sensor. Turn the projector off
and unplug it. Contact Epson for
help.
PowerLite 822p/83c Projector
°
C) and
9
-
페이지 인쇄