Toshiba 13A24 소유자 매뉴얼 - 페이지 18

{카테고리_이름} Toshiba 13A24에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba 13A24 20 페이지. Toshiba owner's manual color television 19a20
Toshiba 13A24에 대해서도 마찬가지입니다: 소유자 매뉴얼 (47 페이지), 서비스 매뉴얼 (32 페이지)

페이지 인쇄

Cleaning and Care

WARNING: TV sets use High Voltage. Do not try to remove the cabinet back. Refer servicing to qualified service personnel.

To clean the TV screen:

1. First remove the plug from the power outlet to avoid

possible shock hazard.

2. Use a clean cellulose sponge or chamois cloth

dampened with a solution of mild detergent and

warm water to clean TV screen and trim. Do not use

too much water on the TV screen. Water spills into

the cabinet and may cause damage to the TV.

Avoid excess water.

3. Remove any extra moisture with the same cloth or a

dry one.

Before Calling Service Personnel

Before calling service personnel, please check the following chart for a possible cause of the problem you are experiencing.

A minor adjustment on your part may eliminate the problem and restore your TV reception.

Problem

TV will not turn on

No picture, no sound

No sound, picture OK

Poor sound, picture OK

Poor picture, sound OK

Poor reception of broadcast channels

No UHF, VHF OK

Unable to select a certain channel

Black box appears on the screen

Multiple images (ghosts)

Poor color or no color

The Remote Control does not operate

Caution: Never use strong solvents such as thinner, benzene or

Checks and Adjustments

Make sure the power cord is plugged in, then press POWER button.

Check battery in remote. (Maybe batteries are "dead".)

If watching VCR, make sure TV is tuned to channel 3 or 4.

Check antenna/cable connections.

Maybe sound is muted. Try pressing VOLUME s button.

Try another channel. (Maybe station trouble.)

Try another channel. (Maybe station trouble or local interference

from appliance.)

Check antenna/cable connections.

Try another channel. (Maybe station trouble or local interference.)

Adjust Picture menu.

Try another channel.

Check antenna connections.

If using VCR, check TV/VCR switch on the VCR.

Make sure TV/CABLE function is in "TV" mode.

That channel may be locked out with BLOCK CHANNEL function, or

erased with the ADD/ERASE function.

Text may be turned on.

Try another channel. (Maybe station trouble.)

Use a highly directional outdoor antena.

Try another channel. (Maybe station trouble or local interference.)

Adjust TINT and/or COLOR in the Picture menu.

If you change the direction of the TV while the TV is activated, the

picture may suffer from color shading. If so, turn off the TV and

allow for about 30 minutes to cool, then turn on the TV again.

The picture should improve.

Maybe something was between the Remote and the remote sensor.

Maybe batteries are dead. Try replacing batteries with new ones.

Insert them with the correct polarity.

To maintain the finish and appearance of the cabinet,

polish it from time to time with a quality furniture

polish.

other chemicals on or near cabinet, as they might

damage the finish of the cabinet.

Page