Toshiba 14AR22 서비스 매뉴얼 - 페이지 16
{카테고리_이름} Toshiba 14AR22에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba 14AR22 30 페이지.
페이지 인쇄
14AR22
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:
1. The unit of resistance "ohm" is omitted.
(K=k Ω =1000 Ω , M=M Ω )
2. All resistors are 1/16 watt, unless otherwise noted.
3. All capacitors are µ F, unless otherwise noted.
(P=pF=µµF)
4. (G) indicates ±2% tolerance may be used.
5.
indicates line isolated ground.
6.
indicates hot ground.
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connected
between points indicated and chassis ground, line
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.
2. All voltages measured with 1000µ V B & W or Color
signal.
1 1.0 Vp-p
Horiz. Rate
6 67.0 Vp-p
Horiz. Rate
q 8.4 Vp-p
Horiz. Rate
WAVEFORMS
2 2.8 Vp-p
3 2.6 Vp-p
Horiz. Rate
Horiz. Rate
7 80.0 Vp-p
8 3.0 Vp-p
Horiz. Rate
Vert. Rate
w 40.8 Vp-p
e 98.0 Vp-p
Vert. Rate
Horiz. Rate
WAVEFORM MEASUREMENT CONDITIONS:
1. Photographs taken on a standard gated color bar
signal, the tint setting adjusted for proper color. The
wave shapes at the red, green and blue cathodes of
the picture tube depend on the tint, color level and
picture control.
2.
indicates waveform check points (See chart,
waveforms are measured from point indicated to
chassis ground.)
å
AND SHADED (
= SAFETY RELATED PARTS.
' MARK= X-RAY RELATED PARTS.
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
4 2.7 Vp-p
Horiz. Rate
9 2.3 Vp-p
Horiz. Rate
r 1,160 Vp-p
Horiz. Rate
15
) COMPONENTS
5 65.0 Vp-p
Horiz. Rate
0 116.0 Vp-p
Horiz. Rate
t 415.0 Vp-p
Power Supply Rate