Toshiba 20W300PG 매뉴얼 - 페이지 6

{카테고리_이름} Toshiba 20W300PG에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba 20W300PG 25 페이지.

페이지 인쇄

Connecting external equipment continued,

Aerial cables:

Connect the aerial to the socket on the rear of the televi-

sion. If you use a decoder and/or a media recorder it is

essential that the aerial cable is connected through the

decoder and/or through the media recorder to the television.

SCART leads:

Connect the media recorder IN/OUT socket to the televi-

sion. Connect the decoder TV socket to the television.

Connect the media recorder SAT socket to the decoder

MEDIA RECORDER socket.

Before running APS (AUTO PROGRAMMING SYSTEM) put

your decoder and media recorder to Standby.

A wide variety of external equipment can be connected

to the back of the television, therefore the relevant

owners manuals for all additional equipment must be

referred to.

NOTE: Becuse FAV CVBS and SVHS Y are connected

parallelly, the picture may blend if the two peripher-

als are used at the same time. Likewise, because

SVHS C and SCART II R are connected parallelly,

the picture may blend if the two peripherals are used

at the same time. Thus these two are not to be used

at the same time.

If connecting S-VIDEO equipment, set the INPUT for

AV-4

S. See

page

18.

If the television automatically switches over to monitor

external equipment, return to normal television by pressing

the desired programme position button. To recall external

equipment, press

to select between

AV-2S, AV-4, AV-4S, YPbPr, HDMI or PC RGB.

A01-ENG-(20-23W300PG)-XX790W-MB22-(1705-CT865)-(PCPIP)-10048610&11-50106343.p65

• Power off both computer and TV before making any con-

nections.

• Connect the PC cable to the PC input of your TV and to the

15-pin connector on the rear of your computer.

• Tighten the screws on the plugs until the connectors are

fastened securely.

• If you are using Windows operating system running on a

PC with a Microsoft Plug&Play compatible video card, your

system will select the appropriate timing for your monitor.

• For PC sound use the stereo jack socket located at the right

side of the tuner.

High Definition

Your TV is capable of displaying High Definition pictures

from devices such as a High Definition Satellite Receiver

or DVD Player. These devices must be connected via the

HDMI socket or YPbPr (Component) sockets. These sock-

ets can accept either 720p or 1080i signals.

PLEASE NOTE: Although this television is able to connect

to HDMI equipment, it is possible that some equipment

may not operate correctly. HDMI cables should be less

than 5m.

NOTE: It is recommended that approved HDMI cables up to

HDMI, the HDMI logo, and High Definition Multi Media Inter-

face are trade marks, or registered trade marks of HDMI

licensing, LLC.

TV, AV-1, AV-2,

English

- 7 -

Connecting the PC via PC input

5m long is used. If the unit has DVI output, a special

conversion cable from DVI to HDMI will be required.

11.06.2007, 16:39