Toshiba 24 WL3A Series 사용 설명서 - 페이지 20

{카테고리_이름} Toshiba 24 WL3A Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba 24 WL3A Series 38 페이지.
Toshiba 24 WL3A Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (9 페이지), 사용 설명서 (45 페이지)

페이지 인쇄

3 AM search and upgrade mode

Your TV will search for new upgrades at 3:00 o'clock

if Automatic scanning option is set to Enabled and if

the TV is connected to an aerial signal or to Internet. If

a new software is found and downloaded successfully,

it will be installed at the next power on.

Note: Do not unplug the power cord while led is blinking during

the reboot process. If the TV fails to come on after the upgrade,

unplug, wait for two minutes then plug it back in.

All updates are automatically controlled. If a manual search

is carried out and no software is found then this is the current

version.

Troubleshooting & Tips

will not turn on

Make sure the power cord is plugged in securely to a

wall outlet. Press the Power button on the TV.

Poor picture

• Check if you have correctly tuned the TV.

• Low signal level can cause picture distortion. Please

check antenna connections.

• Check if you have entered the correct channel

frequency if you have performed manual tuning.

No picture

• TV is not receiving any signal. Make sure the correct

source has been selected.

• Is the antenna connected properly?

• Is the antenna cable damaged?

• Are suitable plugs used to connect the antenna?

• If you are in doubt, consult your dealer.

No sound

• Check if the TV sound is muted. Press the Mute

button or increase the volume to check.

• Sound is coming from only one speaker. Check the

balance settings from Sound menu.

Remote control - no operation

• The batteries may be exhausted. Replace the

batteries.

• The batteries maybe inserted incorrectly. Refer to

the section "Inserting the Batteries into the Remote".

No signal on an input source

• It is possible that no device is connected.

• Check the AV cables and connections from your

device.

• Check the device is switched on.

Recording unavailable

To record a programme, you should first correctly

connect a USB storage device to your TV, while the

TV is switched off. You should then switch on the TV

to enable the recording feature. If you cannot record,

check the storage device is correctly formatted and

there is sufficient space.

USB is too slow

If a "USB storage device writing speed too slow to

record" message is displayed on the screen while

starting a recording, try restarting the recording. If you

still get the same error, it is possible that your USB

storage device does not meet the speed requirements.

Try using a different USB storage device.

PC Input Typical Display Modes

The following table is an illustration of some of the

typical video display modes. Your TV may not support

all resolutions.

Index

English - 19 -

Resolution

Frequency

640x480

800x600

1024x768

1152x864

1280x768

1360x768

1280x960

1280x1024

1400x1050

1440x900

1920x1080

60Hz

75Hz

56Hz

60Hz

72Hz

75Hz

60Hz

70Hz

75Hz

60Hz

75Hz

60Hz

75Hz

60Hz