Toshiba 24 WM3C Series 사용 설명서 - 페이지 10

{카테고리_이름} Toshiba 24 WM3C Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba 24 WM3C Series 50 페이지.
Toshiba 24 WM3C Series에 대해서도 마찬가지입니다: 사용 설명서 (50 페이지)

페이지 인쇄

4. Settings

You can manage the settings of your TV using the

options of this menu. Refer to Settings Menu Content

section for more information.

5. Sources

You can manage your input source preferences using

the options of this menu. To change the current source

or use your TV as a wireless display device highlight

one of the options and press OK.

5.1. Source Settings

You can access the source settings menu directly using

this option. Edit the names, enable or disable selected

source options.

Inserting the Batteries into the Remote

Remove the back cover to reveal the battery compart-

ment. Insert two size AAA batteries. Make sure the (+)

and (-) signs match (observe correct polarity). Do not

mix old and new batteries. Replace only with same or

equivalent type. Place the cover back on.

A message will be displayed on the screen when the

batteries are low and must be replaced. Note that when

the batteries are low, the performance of the remote

control may be impaired.

Power Connection

IMPORTANT: The TV set is designed to operate on a

220-240V AC, 50 Hz supply. After unpacking, allow the

TV set to reach the ambient room temperature before

you connect the set to the mains. Plug the power cord

to the mains socket outlet.

Power Connection (**)

IMPORTANT: The TV set is designed to operate on

a 12 V DC supply. For this, an adaptor is used which

gives 12 V voltage. Connect this adaptor to a system

that supplies 110-240V AC, 50/60Hz.

After unpacking, allow the TV set to reach the ambient

room temperature before you connect the set to the

mains.

AC adaptor

Power Input, DC 12 V terminal

Important safety information

Be sure to ground the connection

Connect the ground terminal of the AC

adaptor with the ground terminal provided at

the power outlet using the enclosed power

cord. If the provided plug does not fit your

outlet, consult an electrician for replacement

Surely connect the ground wire.

Antenna Connection

Connect the aerial or cable TV plug to the aerial input

(ANT) socket or satellite plug to the satellite input (LNB)

socket located on the rear side of the TV.

Rear side of the TV

1. Satellite

2. Aerial or cable

If you want to connect a device to the TV, make

sure that both the TV and the device are turned off

before making any connection. After the connection

is done, you can turn on the units and use them.

English - 9 -

properly

of the obsolete outlet.

LNB

ANT

(**) Limited Models Only