Epson PowerRIP Stylus 설치 및 운영 매뉴얼 - 페이지 10

{카테고리_이름} Epson PowerRIP Stylus에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson PowerRIP Stylus 44 페이지. Macintosh & macintosh power pc version 3.1 for stylus color/pro/pro xl

페이지 인쇄

Using PowerRIP With Your Desktop Applications

1. If your Mac has sufficient RAM, you may keep PowerRIP open in the back-

ground while you work in other applications. If you don't have enough RAM

(your Mac will tell you so), you must quit

2. When setting up your documents, be sure to consider the printable area of

your Epson Stylus. Minimum margins can be viewed in Page Setup menus.

3. You cannot print directly to PowerRIP unless you have multiple networked

Mats. Instead you must create a PostScript file (save to disk), an option avail-

able in all PostScript applications. PostScript files should be saved to the

printer queue folder you created inside the PowerRIP 3.1 folder. If you saved

the PostScript file to some other destination, you can drag and drop it into

the proper printer queue folder. Don't save jobs to the Printed Jobs folder

inside the printer queue; jobs reside there after they have printed.

4. When you print a job and PowerRIP is open in the background, your job will

start processing as soon as it gets to the printer queue. If you had to quit

PowerRIP because of low memory, use the following instructions: After the

PostScript file has been sent to the printer queue, quit the application, launch

PowerRIP, and open the printer you previously created (under

Open Printer-open

select

printer icon). Your job will process and print after the printer starts your job.

Quick Start

Installing PowerRIP on Client Macintosh Computers

Any networked Macintosh can be used as a client. See note on page 2 if you

have less than 8 MB of RAM.

Disk 1

1. Insert

2. Click

Continue.

3. Click on Custom,

4. Follow the prompts to insert

When the installation is complete, click OK and eject Disk 1.

Printing To PowerRIP Server From Client Mats

A Client is any Macintosh connected to the Server Macintosh via AppleTalk or

Ethertalk. When the PowerRIP Control Panel and a printer are open on a server

Mac, you will see the name of your printer in the Chooser of a client Mac. Select

the proper PPD as in previous instructions and print directly to the printer; there is

no need to create a PostScript file.

the printer queue folder and double click on the

(for networked Mats)

and double click on installer icon.

then highlight PowerRIP

Bit-my Graphics Corporation

Introduction/lnstallation

PowerRIP.

3.1 Client

Disk

2 through

File at

on Install.

and click

Disk 1

4, and then

top

again.