MSI 612BF 매뉴얼 - 페이지 26

{카테고리_이름} MSI 612BF에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. MSI 612BF 45 페이지. 3d-agp vga / 3d-audio m/b for socket 370
MSI 612BF에 대해서도 마찬가지입니다: 사용자 설명서 (48 페이지)

페이지 인쇄

The choice: PCI Slot, Onboard .



AC97 Audio/Modem: This item allows you to decide to enable/disable the 810 chipset

family to support AC97 Audio/Modem.

The choice: Enabled, Disabled.



IDE HDD Block Mode: Block mode is also called block transfer, multiple commands, or

multiple sector read/write. If your IDE hard drive supports block mode (most new drives

do), select Enabled for automatic detection of the optimal number of block read/writes per

sector the drive can support.

The choice: Enabled, Disabled



Power on Function : Select Keyboard (Hot Key / Pass word) / PS/2 Mouse Power on

Function.

The choice : BUTTON ONLY , Keyboard 98 , Password , Hot Key , Mouse Left , Mouse Righe ,

Any Key.



Onboard FDC Controller: Select Enabled if your system has a floppy disk controller

(FDC) installed on the system board and you wish to use it. If you install and-in FDC or the

system has no floppy drive, select Disabled in this field.

The choice: Enabled, Disabled.



Onboard Serial Port 1/Port 2: Select an address and corresponding interrupt for the first

and second serial ports.

The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.



UART Mode Select: The Default setting is Normal.

IRDA: HP Standard Mode IR.

ASKIR: ASK standard Mode IR.



Onboard Parallel port: This field allows the user to select the LPT port. The default value

is 378H.

378H:

Enable Onboard LPT port and address is 378H.

278H:

Enable Onboard LPT port and address is 278H.

3BCH:

Enable Onboard LPT port and address is 3BCH.

Disabled: Disable Onboard CHIP's LPT port.

NOTE:

Parallel Port address is 378H/3BCH that selects the rounting of IRQ7 for LPT1.

Parallel Port address is 278H that selects the rounting of IRQ5 LPT1.



Onboard Parallel port Mode: This field allows the user to select the parallel port mode.

The default value is ECP + EPP.

Normal:

Standard mode. IBM PC/AT Compatible bidirectional parallel port.

EPP:

Enhanced Parallel Port mode.

ECP:

Extended Capabilities Port mode.