MSI 612BF 매뉴얼 - 페이지 29

{카테고리_이름} MSI 612BF에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. MSI 612BF 45 페이지. 3d-agp vga / 3d-audio m/b for socket 370
MSI 612BF에 대해서도 마찬가지입니다: 사용자 설명서 (48 페이지)

페이지 인쇄



Suspend Type: Select the Suspend Type.

The choice: PWRON Suspend, Stop Grant.



MODEM Use IRQ: This determines the IRQ in which the MODEM can use.

The choice: 3, 4, 5, 7, 9, 10, 11, NA.



Suspend Mode: When enabled and after the set time of system inactivity, all devices

except the CPU will be shut off.

The choice: Enabled, Disabled.

HDD Power Down: When enabled and after the set time of system inactivity, the hard disk



drive will be powered down while all other devices remain active.

The choice: Enabled, Disabled.



Soft-Off by PWRBTN: Pressing the power button for more than 4 seconds forces the

system to enter the Soft-Off state when the system has "hung."

The choice: Delay 4 Sec, Instant-Off.



CPU THRM-Throttling: Select the CPU THRM-Throttling rate.

The choice: 25.0%, 37.5%, 50.0%, 62.5%, 75.0%, 87.5%.



PM Events:PM events are I/O events whose occurrence can prevent the system from

entering a power saving mode or can awaken the system from such a mode. In effect, the

system remains alert for anything which occurs to a device which is configured as Enabled ,

even when the system is in a power down mode.

Primary IDE 0

Primary IDE 1

Secondary IDE 0

Secondary IDE 1

FDD, COM, LPT Port

PCI PIRQ[A-D] #

3-6 PNP/PCI CONFIGURATION SETUP

This section describes configuring the PCI bus system. PCI, or Personal Computer

Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the

CPU itself uses when communicating with its own special components. This section covers

some very technical items and it is strongly recommended that only experienced users should

make any changes to the default settings.

PnP/PCI Configurations