Epson RX500 - Stylus Photo Color Inkjet 여기에서 시작하기 매뉴얼 - 페이지 6

{카테고리_이름} Epson RX500 - Stylus Photo Color Inkjet에 대한 여기에서 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson RX500 - Stylus Photo Color Inkjet 9 페이지. Product support bulletin(s)
Epson RX500 - Stylus Photo Color Inkjet에 대해서도 마찬가지입니다: 소유자 매뉴얼 (15 페이지), 사용자 설명서 (20 페이지), 제품 정보 시트 (4 페이지), 사양 (2 페이지), 설정 매뉴얼 (2 페이지), 사용자 설명서 (12 페이지), 업데이트 (1 페이지), 제품 지원 게시판 (6 페이지), 제품 지원 게시판 (1 페이지), 사용 설명서 (4 페이지)

Epson RX500 - Stylus Photo Color Inkjet 여기에서 시작하기 매뉴얼
9
When you see a message that you have successfully installed the
RX500 drivers, click Next.
10
Continue following the instructions on the screen to install the rest of
your software.
Note: Installation may take several minutes. Don't cancel the
installation or start other programs.
11
When installation is finished, click Print Test Page to make sure your
software is installed correctly.
12
After the test page prints, click Exit.
13
Register your RX500 as instructed, then remove the CD-ROM.
Now you're ready to copy, scan, and print. See "Any Questions?" to the right
to find out how.
Macintosh
1
Insert the Epson CD-ROM in your CD-ROM or DVD drive.
2
Mac
®
OS X: Double-click the EPSON CD-ROM icon, then double-click
the
EPSON OS X Installer icon.
Mac OS 8.6 to 9.x: Double-click the
Installer icon.
3
When you see this screen,
click Install.
4
Read the license agreement and
click Agree to continue.
5
Follow the instructions on the
screen to install the software. You
may need to enter your
administrator password.
Note: Installation may take several minutes. Don't cancel the
installation or start other programs.
6
When prompted, restart your Macintosh. Then double-click your
EPSON CD-ROM icon, if necessary, and double-click your
installer icon to continue with installation.
7
When you see this screen, click
Install to finish installing your
software.
Note: Installation may take several
minutes. Don't cancel the
installation or start other programs.
8
At the end of installation, click Exit.
9
Register your RX500 as instructed,
then remove the CD-ROM.
10
Make sure the RX500 is turned on, then
lift up the scanner.
11
Remove the yellow sticker and plug the
square end of a USB cable into the USB
port on the RX500. Then route the cable in
the slot as shown.
Caution: Make sure the USB cable fits securely into the slot. The
USB connector may snap if the cable is not routed correctly and
the scanner is closed with force.
12
Close the scanner carefully.
13
Plug the flat end of the cable into any available USB port on your
Macintosh.
EPSON OS 8 and 9
continue