Toshiba e-studio 2008a 안전 정보 매뉴얼 - 페이지 14
{카테고리_이름} Toshiba e-studio 2008a에 대한 안전 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba e-studio 2008a 25 페이지. Multifunctional digital color systems
페이지 인쇄
General Precautions
When installing or moving
For the U.S.A. and Canada
Multifunctional Digital Systems require 120 V, 12 A, 50/60 Hz electric power.
For the EU
Multifunctional Digital Systems require 220 to 240 V AC, 8 A, 50/60 Hz electric power.
Except the U.S.A., Canada and the EU
Multifunctional Digital Systems require 220 to 240 V AC, 8 A, 50/60 Hz electric power.
Do not use a power supply with a voltage other than that specified.
Avoid multiple connections in the same outlet. This could cause a fire or give you an electric shock. If
you are considering increasing the number of outlets, contact an electrician.
Always connect this Multifunctional Digital Systems to an outlet with a ground connection to avoid
the danger of fire or electric shock in case of short-circuiting. Contact your service representative for
the details. Be sure to use a 3-conductor, grounded wall outlet.
In areas, except the U.S. and Canada, where a 2-pin plug is used, the Multifunctional Digital Systems
must be grounded for safety. Never ground it to a gas pipe, a water pipe, or any other object not
suitable for grounding.
Plug the power cord securely into the outlet. If it is not plugged in properly, it could heat up and
cause a fire or give you an electric shock.
Do not damage, break or attempt to repair the power cord.
The following things should not be done to the power cord.
- Twisting it
- Bending it
- Pulling it
- Placing anything on it
- Heating
- Situating it near radiators or other heat sources
This could cause a fire or give you an electric shock. If the power cord is damaged, contact your
service representative.
Do not install the equipment by yourself or try to move it once it has been installed. This could result
in an injury or damage to the device. Contact your service representative if the equipment needs to
be installed or moved.
The socket outlet shall be near the equipment and be easily accessible.
Pull out the plug from the outlet more than once a year to clean around the prongs. Accumulating
dust and dirt could cause a fire due to the heat released by electric leakage.
When removing the plug from the outlet, do not pull the power cord. Always hold the plug when
removing it from the outlet. If the power cord is pulled, the wires may break and this could cause a
fire or give you an electric shock.
Make sure that the ventilation holes are not blocked.
If the temperature within the Multifunctional Digital Systems becomes too high, a fire could result.
Both the Paper Feed Pedestal and the Large Capacity Feeder have 4 adjusters (antiskid devices)
underneath. After the equipment has been moved and installed, be sure to turn and lower them to
fix it.
For the Paper Feed Pedestal, fix the fall-prevention stoppers after the adjusters have been adjusted.
14 Safety Information