Toshiba e-studio 2309a 소프트웨어 설치 매뉴얼 - 페이지 19

{카테고리_이름} Toshiba e-studio 2309a에 대한 소프트웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba e-studio 2309a 48 페이지.

2.INSTALLATION IN WINDOWS

 Installing the drivers using Plug and Play

You can use the Windows Plug and Play function to install the drivers in Windows Vista / Windows Server

2008. When using Plug and Play, first the scanner driver is installed, and then the printer driver.

For Windows 7, Windows 8, Windows Server 2008 R2, or Windows Server 2012, use the installer to install

the drivers. The Windows Plug and Play function cannot install them.

 P.14 "Installing the drivers using the installer"

An additional printer wizard can also be used to install the printer driver. To use the additional printer

wizard, select the USB port or the network port that the equipment is connected to using "Choose a Printer

Port".

Connect this equipment to the computer using a USB cable, and then start the

computer.

Do not connect or disconnect the USB cable when starting up the computer.

Turn on the equipment.

The Found New Hardware dialog box appears.

If it does not appear, turn off this equipment, and then wait approximately 10 seconds before turning it

on again. If you turn this equipment on immediately after turning it off, it may not function correctly.

Click "Locate and install driver software (recommended)".

The dialog box requesting the disk (Client Utilities/User Documentation DVD*) appears.

The Client Utilities DVD is available for e-STUDIO2802A/2802AM/2802AF.

If the User Account Control dialog box appears, click [Allow] or [Continue].

2 INSTALLATION IN WINDOWS

Installing the Drivers in Windows