Toshiba e-studio 2802am 소프트웨어 설치 매뉴얼 - 페이지 38

{카테고리_이름} Toshiba e-studio 2802am에 대한 소프트웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba e-studio 2802am 48 페이지. Multifunctional digital systems
Toshiba e-studio 2802am에 대해서도 마찬가지입니다: 빠른 매뉴얼 (2 페이지)

페이지 인쇄
Toshiba e-studio 2802am 소프트웨어 설치 매뉴얼
4 INSTALLATION IN UNIX/Linux

Configuring the Printer Using CUPS

Refer to the following pages to install the PPD file and configure the printer in UNIX/Linux for LPR printing,
IPP printing or USB printing.
 P.36 "Configuring the printer for LPR printing"
 P.37 "Configuring the printer for IPP printing"
 P.38 "Configuring the printer for USB printing"
 Configuring the printer for LPR printing
To set up CUPS, copy the PPD file onto the UNIX/Linux workstation, install the printer, and then configure
PPD. You can use a browser to install the printer and configure PPD.
After extracting the PPD file, restart the CUPS daemon.
1
Insert the Install Disc into the disc drive.
2
Log on to the root account.
3
Install the RPM package with the rpm command.
4
Enter the following command:
service cups start
If the CUPS has already been started, stop the CUPS service once by entering "service cups stop"
command, and then enter the above command to restart the CUPS service.
5
Open the browser and locate CUPS by typing "http://localhost:631/" in the address
box.
When you use Red Hat Linux, access CUPS with the following command:
/usr/bin/cupsconfig
6
Click [Add Printer] on the [Administration] tab.
7
Select [LPD/LPR Host or Printer] and click [Continue].
8
Enter "lpd://<IP address>/Print" in the [Connection] box and click [Continue].
Make sure to capitalize the "P" in "Print" for the device URI.
9
Enter the printer name, description, and location of the printer in each box, and click
[Continue].
If a new printer name is a duplicate of a name already in the printer list, the new printer will replace
the original printer.
10
Select [Toshiba] in the [Make] box and click [Continue].
If you do not see [TOSHIBA] in the [Make] list, restart CUPS.
11
Select the model name in the [Model] list and click [Add Printer].
12
Go to the following page for configuring the print options:
 P.39 "Configuring the print options"
36

Configuring the Printer Using CUPS