Epson Stylus Pro 7600 Photographic Dye Ink 빠른 참조 매뉴얼 - 페이지 5

{카테고리_이름} Epson Stylus Pro 7600 Photographic Dye Ink에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Pro 7600 Photographic Dye Ink 11 페이지. Epson stylus pro 7600: brochure
Epson Stylus Pro 7600 Photographic Dye Ink에 대해서도 마찬가지입니다: 브로셔 및 사양 (24 페이지), 포장 풀기 및 설정 매뉴얼 (24 페이지), 정보 매뉴얼 (16 페이지), 사양 (4 페이지), 빠른 설치 매뉴얼 (34 페이지), 제품 정보 (15 페이지), 보증 (8 페이지), 브로셔 및 사양 (8 페이지), 브로셔 및 사양 (16 페이지), 제품 참조 매뉴얼 (28 페이지), 수동 업데이트 (4 페이지)

If you notice banding or missing colors in your printouts,

the print head may need cleaning. First print a nozzle

check pattern to find out the condition of the print head.

Then run a cleaning cycle, if neccessary, and print another

check pattern to test the results.

Load a sheet of coated ink jet paper (or roll paper)

in the printer.

Press the SelecType button, then press the

button so that TEST PRINT appears on the

display.

Press the

button twice, then press Enter. The

nozzle check prints as shown:

If all the lines in the nozzle check are complete, with

no missing dots or gaps, the print head doesn't need

cleaning.

If the pattern is missing dots or lines, as shown below,

you need to run a cleaning cycle.

INCH

If You Notice Banding...

If you still see banding after running a cleaning cycle, you

may need to align the print head as described in the

Printer Guide.

Banding can also be caused by selecting the incorrect

paper type in your printer software. Be sure to select the

paper you're using in the EPSON printer software or in a

third-party RIP. If your paper is not listed, you can use the

printer's SelecType menu to create a custom paper type

(see "Optimizing the Settings for Your Paper" in the

Printer Guide).

Make sure all the Ink Out lights on the printer's

control panel are off. If an Ink Out light is

flashing or on, you need to replace the

corresponding ink cartridge instead.

Press the Cleaning button and hold it for at least

3 seconds. The Pause light flashes as the printer

cleans its print head. The cleaning cycle takes

about a minute and does not use any paper.

To avoid damaging the printer, don't turn it off

until the cleaning cycle is finished and the

Pause light has stopped flashing.

When the Pause light goes off, follow steps

1 through 3 to run another nozzle check to make

sure the print head is clean.