Philips Q-Line 55BDL3010Q 사용자 설명서 - 페이지 32
{카테고리_이름} Philips Q-Line 55BDL3010Q에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Philips Q-Line 55BDL3010Q 35 페이지. Signage solutions
Philips Q-Line 55BDL3010Q에 대해서도 마찬가지입니다: 사용자 설명서 (38 페이지)
페이지 인쇄
How to setup the settings in the menu to
control all the monitors at the same time and
individually via RC?
How does the RC work?
Daisy chained by RS232 and no IR cable
Daisy chain : no connection of RS232 and IR
cable
22
1. The first display sets as "Primary" on OSD
(Advanced option/IR control item), others set as
"Secondary".
2. The setup OSD will show on top left side of
the display. (Toggle MENU will show again if it
disappears)
3. Default setting: ID NO: 0, GP NO: 0, this setting
can control all displays by IR.
The "+", "-" can change "ID NO" to control
signal display by "Monitor ID".
The "UP", "DOWN" can change "GP NO" to
control multi-display by "Group ID".
*The first display is always controlled by IR.
No setting is required. Connect with IR cables
and control by IR.
*This may cause out-of-synchronizm
phenomenon. It is suggested to use the above
settings with RS-232 cable.