Philips S line 222S1 사용자 설명서 - 페이지 27
{카테고리_이름} Philips S line 222S1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Philips S line 222S1 31 페이지.
Philips S line 222S1에 대해서도 마찬가지입니다: 사용자 설명서 (31 페이지), 사용자 설명서 (31 페이지)
페이지 인쇄
9. Troubleshooting & FAQs
Horizontal flicker appears
•
Adjust the image using the "Auto"
function in OSD Main Controls.
•
Eliminate the vertical bars using
the Phase/Clock of Setup in OSD
Main Controls. It is valid only in VGA
mode.
Image appears blurred, indistinct or too
dark
•
Adjust the contrast and brightness
on On-Screen Display.
An "after-image", "burn-in" or "ghost
image" remains after the power has
been turned off.
•
Uninterrupted display of still or
static images over an extended
period may cause "burn-in", also
known as "after-imaging" or "ghost
imaging", on your screen. "Burn-in",
"after-imaging", or "ghost imaging"
is a well-known phenomenon in
LCD panel technology. In most
cases, the "burn-in" or "after-
imaging" or "ghost imaging" will
disappear gradually over a period
of time after the power has been
switched off.
•
Always activate a moving screen
saver program when you leave your
monitor unattended.
•
Always activate a periodic screen
refresh application if your LCD
monitor will display unchanging
static content.
•
Failure to activate a screen saver, or
a periodic screen refresh application
may result in severe "burn-in" or
"after-imaging" or "ghost imaging"
symptoms that will not disappear
and cannot be repaired. The
damage mentioned above is not
covered under your warranty.
Image appears distorted. Text is fuzzy
or blurred.
•
Set the PC's display resolution
to the same mode as monitor's
recommended screen native
resolution.
Green, red, blue, dark, and white dots
appears on the screen
•
The remaining dots are normal
characteristic of the liquid crystal
used in today's technology, Please
refer the pixel policy for more detail.
For further assistance, refer to the
Service contact information listed in
Regulation & Service Information
Manual and contact Philips customer
service representative.
* Functionality different according to
display.
9.2 General FAQs
Q1:
When I install my monitor what
should I do if the screen shows
'Cannot display this video
mode'?
Ans.: Recommended resolution for
this monitor: 1920 x 1080.
•
Unplug all cables, then connect your
PC to the monitor that you used
previously.
•
In the Windows Start Menu, select
Settings/Control Panel. In the
Control Panel Window, select the
Display icon. Inside the Display
Control Panel, select the 'Settings'
tab. Under the setting tab, in box
labelled 'desktop area' , move the
sidebar to 1920 x 1080 pixels.
•
Open 'Advanced Properties' and
set the Refresh Rate to 60 Hz, then
click OK.
25