Philips VSS94705T 중요 참고 사항 - 페이지 4
{카테고리_이름} Philips VSS94705T에 대한 중요 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Philips VSS94705T 7 페이지. Colour observation monitor
페이지 인쇄2a Monitor is used as stand alone system:
Connect a system camera to the slave-in input (11).
A third party camera can be connected to the aux. in
input (9).
2b Monitor is used as slave monitor:
See figure at the top of the page.
Connect the slave monitor to the system monitor (16).
Remark: If a second slave monitor is used, it has to be
connected to the slave-out (12) output.
3 Check and adjust the settings of the following controls:
Cable length compensation selector (8)
•
Last in line switch (13)
•
Input selection switch (14)
•
Read the 'settings' section for the correct control settings.
4 Connect the slave monitor to the mains (15).
5 Switch on the main power switch (10).
camera in
1
2
3
4
video
audio
in
out
out
aux
VCR
cable length
100m
0-50m
Settings
There are three controls located at the back of the slave
monitor. By means of these controls the slave monitor
can be adapted to the configuration of your observation
system. These controls are:
Cable length selector
cable length
100m
200m
0-50m
300m
100m
0-50m
5
slave
16
out
max 24V 2A
power
out
alarm gnd
11
slave
12
in
out
200m
video
13
I O
audio
in
14
300m
slave aux
in
power
aux
15
8
9
10
CL 66610005_215a.AI
slave
in
out
cable length
200m
video
I O
audio
in
300m
slave aux
in
power
aux
CL 66610005_205.AI
This selector adapts the slave monitor input to the length
of the system cable connecting system monitor and slave
monitor. This to optimize the picture and sound quality.
Set the cable length selector switch to the correct cable
length. The length set must be the same as the length of
the system cable between slave monitor and system
monitor. The max. allowed cable length is 300m/900ft.
Last in line switch
cable length
100m
200m
audio
0-50m
300m
Set this switch to 0 when the slave-out output is not used
•
(this monitor is last in line).
Set this switch to 1 when you connect a (second) slave
•
monitor.
Input selection switch
cable length
100m
200m
0-50m
300m
With this switch you can select which input is displayed
on the monitor screen.
slave aux
CL 66610005_210.AI
The slave-in input is selected.
•
The slave monitor reproduces the image and sound of
the system monitor.
Remark: When the slave monitor is used as a stand alone
system the image and sound of the Philips system camera are
reproduced.
slave aux
CL 66610005_211.AI
The aux-in input is selected.
•
When you have connected a non system camera or VCR
to this input, its image and sound will be reproduced.
slave
in
out
video
I O
in
slave aux
in
power
aux
I
O
CL 66610005_206.AI
slave
in
out
video
I O
audio
in
slave aux
in
power
aux
slave aux
CL 66610005_209.AI