Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C 사용자 설명서 - 페이지 5
{카테고리_이름} Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C 31 페이지. 3 cd changer with dolby® pro logic processor, five loudspeakers, 320 watts total power
Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C에 대해서도 마찬가지입니다: 사양 (2 페이지), 매뉴얼 (31 페이지)
페이지 인쇄
GENERAL INFORMATION
General Information
• The type plate (which contains the
serial number) is located at the rear
of the system.
• Recording is permissible if
copyright or other rights of third
parties are not infringed.
• This product complies with the
radio interference requirements of
the European Community.
Environmental Information
All unnecessary packaging has been
omitted. We have tried to make the
packaging easy to separate into three
materials: cardboard (box), polystyrene
foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which
can be recycled and reused if disassembled
by a specialized company. Please observe
the local regulations regarding the disposal
of packaging materials, exhausted
batteries and old equipment.
pg 01-31/P88/22-Eng
5
Energy Star
As an ENERGY STAR
R
Partner; Philips has
determined that this product meets the
R
ENERGY STAR
guidelines for energy
efficiency.
Acknowledgement
Dolby Pro Logic, Dolby B NR and the
double-D symbol d are trademarks of
Dolby Laboratories Licensing Corporation.
Manufactured under license from Dolby
Laboratories Licensing Corporation.
Accessories
(Supplied)
– Remote control
– Batteries (two AA size) for remote
control
– AM loop antenna
– FM wire antenna
– AC power cord
– CS-540 speaker package (includes one
pair of surround speakers and one
center speaker)
Safety Information
• Before operating the system, check that
the operating voltage indicated on the
typeplate (or the voltage indication
beside the voltage selector) of your
system is identical with the voltage of
your local power supply. If not, please
consult your dealer. The typeplate is
located at the rear of your system.
• When the system is switched on, do not
move it around.
• Place the system on a solid base (e.g. a
cabinet).
• Place the system in a location with
adequate ventilation to prevent internal
heat build-up in your system. Allow at
least 10 cm clearance from the rear and
the top of the unit and 5 cm from the
each side.
• The system incorporates a built-in
safety feature that prevents
overheating.
• Do not expose the system to excessive
moisture, rain, sand or heat sources.
• Under no circumstances should you
repair the system yourself, as this will
invalidate the warranty!
3/6/00, 1:26 PM
SAFETY INFORMATION
• If the system is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lens of the CD unit
inside the system. Should this occur, the
CD player will not operate normally.
Leave the power on for about one hour
with no disc in the system until normal
playback is possible.
• Electrostatic discharge may cause
unexpected problems. See whether
these problems disappear if you unplug
the AC power cord and plug it in again
after a few seconds.
• To disconnect the system from the
power supply completely, remove
the AC power plug from the wall
socket.
3139 116 19721
5