Epson Stylus Scan 2000 사용자 설명서 - 페이지 8

{카테고리_이름} Epson Stylus Scan 2000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Scan 2000 24 페이지. Scanning application force quits on mac os 10.4 release of twain pro driver 2.10a;
Epson Stylus Scan 2000에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지), 제품 정보 시트 (4 페이지), 빠른 시작 (4 페이지), 제품 정보 매뉴얼 (13 페이지), 제품 정보 시트 (4 페이지), 제품 지원 게시판 (12 페이지), 사양 (2 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (3 페이지), 제품 지원 게시판 (14 페이지), 매뉴얼 (35 페이지), 온라인 매뉴얼 (10 페이지)

Setting Up Your Stylus Scan 2000

The EPSON Stylus Scan comes with two supports.

Paper support (gray)

Fit the paper support into the slots at the rear of the EPSON Stylus Scan.

Document support (transparent)

Carefully fit the document support into the holes at the rear of the EPSON Stylus

Scan.

document support

Make sure that the Stylus Scan is turned off. It is off when the

protrudes slightly from the surface of the control panel.

Check the label on the back of the Stylus Scan to make sure the voltage required

by the Stylus Scan matches that of the electrical outlet you plug it into. Also, make

sure that you have the correct power cable for your power source.

Caution:

It is not possible to change the Stylus Scan's voltage. If the rated voltage

and your outlet voltage do not match, contact your dealer for assis-

tance. Do not plug in the power cord.

If the power cord is not attached to the Stylus Scan, connect it to the AC inlet at

the back of the Stylus Scan.

Plug the power cord into a properly grounded electrical outlet.

Your Stylus Scan has two ports through which it can be connected to a computer; a

parallel port and a USB port. Use the port appropriate for your computer.

Note:

If your computer has both a parallel and USB port, be sure to follow the correct

steps for connecting to the port you choose.

Do not use the Stylus Scan's parallel port and USB port simultaneously.

Connect the Stylus Scan to one computer at a time.

paper support

power button

Setting Up Your Stylus Scan 2000