Philips 7000 series 사용자 설명서 - 페이지 11

{카테고리_이름} Philips 7000 series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Philips 7000 series 12 페이지. Cordless vacuum
Philips 7000 series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (24 페이지), 빠른 시작 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (17 페이지), 정보 (3 페이지), 브로셔 및 사양 (3 페이지), 브로셔 및 사양 (3 페이지), 빠른 시작 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (8 페이지), 사용자 설명서 (32 페이지), 사용자 설명서 (18 페이지), 매뉴얼 (36 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (20 페이지), 사용자 설명서 (14 페이지), 매뉴얼 (33 페이지), 사용자 설명서 (12 페이지), 사용자 설명서 (20 페이지), 사용자 설명서 (23 페이지), 매뉴얼 (15 페이지), 매뉴얼 (16 페이지), 사용자 설명서 (20 페이지), 문제 해결 매뉴얼 (7 페이지), 사용자 설명서 (22 페이지), 사용자 설명서 (15 페이지), 사용자 설명서 (14 페이지), 사용자 설명서 (32 페이지), 사용자 설명서 (49 페이지), 사용자 설명서 (22 페이지), 사용자 설명서 (18 페이지), 사용자 설명서 (17 페이지), 사용자 설명서 (20 페이지), 사용자 설명서 (21 페이지), 자주 묻는 질문 매뉴얼 (7 페이지), 사용자 설명서 (17 페이지), 사용자 설명서 (11 페이지), 사용자 설명서 (14 페이지), 사용자 설명서 (40 페이지), 빠른 시작 매뉴얼 (20 페이지), 사용자 설명서 (23 페이지), 매뉴얼 (9 페이지), 사용자 설명서 (40 페이지), 사용자 설명서 (24 페이지), 사용자 설명서 (32 페이지), 매뉴얼 (42 페이지), 사용자 설명서 (20 페이지)

Philips 7000 series 사용자 설명서
8

Troubleshooting

Warning
Never remove the casing of the product.
To keep the warranty valid, never try to repair
the device yourself. If you encounter problems
when using this device, check the following
points before requesting service. If the problem
remains unsolved, go to the Philips webpage
www.philips.com/support. When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
Make sure that the AC power plug of the unit
is connected properly.
Make sure that there is power at the AC outlet.
No sound
Adjust the volume.
No response from the unit
Disconnect and reconnect the AC power plug,
then turn on the unit again.
Poor radio reception
Keep the clock radio away from other
electronic devices to avoid radio interference.
Fully extend and adjust the position of the
antenna.
Alarm does not work
Set the clock/alarm correctly.
Clock/alarm setting erased
Power has been interrupted or the power
plug has been disconnected.
Reset the clock/alarm.
Replace the backup batteries.
EN
10
Poor audio quality through
Bluetooth connection
The Bluetooth reception is poor. Move
the Bluetooth enabled device closer to
this unit or remove any obstacle between
them.
The Bluetooth function is not enabled on
your device. Refer to the user manual of
your device to nd out how to enable
Bluetooth.
This unit is connected with another
Bluetooth enabled device. Disconnect and
try again.