Toshiba MJ-1028 서비스 매뉴얼 부록 - 페이지 3

{카테고리_이름} Toshiba MJ-1028에 대한 서비스 매뉴얼 부록을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba MJ-1028 9 페이지. Supplement to the troubleshooting section

1. EA20 Paper Transport Stop Jam

There are a couple of areas that should be looked at when EA20 jamming is occurring.

Check for proper operation of Escape Solenoid (SL6) (part number 4402962760

SOLENOID).

If the Escape Solenoid does not operate properly then an EA20 jam could occur (see

Figure 1). The items to check for include:

o Binding of linkage

o Sticking of plunger

o Defective solenoid

Check the proper return operation of the buffer sensor (PI14).

We have had reports that either the first (M1) or second (M8) feed motors (part

number 6LE67833000 MOTR.S-FEED) could fail. The reports from the field are that

both motors need to be replaced at the same time. The reports state that replacing

one motor does not solve the problem and that both need to be replaced at the same

time.

There are a couple of causes of CB30, one is intermittent and the other is constant.

Intermittent

It has been noted in the field that an intermittent CB30 bin lift motor error may occur;

it usually occurs when the lower bin is driving. The cause is linked to the tie wraps on

the harness being too tight (see Figure 2). Over time, with the bins moving up and

down, damage occurs to the harness resulting in this error. As deemed necessary,

remove the cable ties. However, if the wires have already been damaged you may

need to replace the harness. (upper part number: 4G30851000; lower part number:

4G30852000 CABLE-TRAY)

Figure 1

Paper buckled due to

guide plate not being

lowered by escape

solenoid