Power Supply
Using AC power
WARNING: Always check you have com-
pletely switched off the set, before you
change or disconnect power supply.
1 Check if the power voltage, as shown on
the type plate located on the bottom
of the set, corresponds to your local power
supply. If it does not, consult your dealer or
service center.
2 Connect the power cord to the AC
MAINS~ inlet and the wall socket.The set is
now connected and ready for use.
3 To switch the set off completely, withdraw the
power cord from the wall socket.
4 Install the unit near the AC outlet and where
the AC power plug can be easily reached.
•
Disconnect the power cord from the wall
socket to protect your set during heavy thun-
derstorms. Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.
The type plate is located on the bottom
of the set.
Helpful hints:
–
To avoid unnecessary energy consumption,
always adjust the
after using the set.
Source selector to OFF
General Operation / Tuner
General operation
Switching on and off and selecting the
function
1 To select your sound source, adjust the
Source selector to:
2 To switch off the set, adjust the Source
selector
to OFF position.
3 To switch to LINE IN mode, connect an
external audio source to the LINE-IN inlet.
Helpful hints:
•
The set switches to LINE IN mode auto-
matically when an external audio source is
connected, no matter the set is in CD,
or MW
mode.
•
The LINE-IN inlet is not for earphones.
Adjusting volume and sound
Adjust the sound with the VOLUME and
DBB controls.
Radio reception
1 Adjust the Source selector to FM or
MW.
2 Turn TUNING to tune to a station.
Helpful hints:
To improve radio reception
•
For FM, extend, incline and turn the telescop-
ic antenna for best reception. Reduce its
length if the signal is too strong.
•
For
MW,
the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
CD, FM or
MW.
FM
페이지 인쇄