Toshiba HD-A3KU 소유자 매뉴얼 - 페이지 15

{카테고리_이름} Toshiba HD-A3KU에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba HD-A3KU 48 페이지. Hd dvd player

페이지 인쇄

Step 1: Connecting to a TV

• Connect the player directly to your TV. If you connect the player to a VCR, TV/VCR combination, video selector

or AV ampliﬁ er, the playback picture may be distorted due to copy protection.

• Be sure to turn off the power and unplug both units from the wall outlet before making any connections.

Via HDMI input

HDMI transfers digital audio and uncompressed digital video on

a single cable. As a result, audio cables and video cables don't

need to be connected separately to a device.

HDMI cable (not supplied)

To HDMI OUTPUT

Via component video input

Some discs may be down converted or require HDMI

connection.

Component video cables

(not supplied)

To COMPONENT

VIDEO OUTPUT

Via VIDEO (yellow) input

Composite video (yellow) cable

(not supplied)

To VIDEO OUTPUT

Note

• This player supports simultaneous output of video on its HDMI and component video ports. However, some discs may restrict output of video

on the component video ports when viewing high deﬁ nition content or up-converted DVD content. The resolution on the HDMI output will be

the same as the resolution output on the component video output. Thus, because the HDMI output can change automatically to match the

maximum available resolution of your display, if you connect both the HDMI output and component output, the resolution on the component

output will change if the HDMI output auto-adjusts.

_ H D - A 3 K U _ E n g . i n d d 1 5

Notes

• When the HDMI connection is not veriﬁ ed, an error message appears

on the front panel display. In this case, disconnect the HDMI cable

then connect it again, or turn off the connected HDMI device then

turn it on.

• HDMI output is digital only, DVI analog is not supported.

• HDMI is an evolving technology, so it is possible that some devices

may not operate properly with this player.

• To get the most possible beneﬁ t from Dolby Digital Plus, you should

connect your HD DVD player to your AV receiver using its HDMI

HDMI INPUT

input. If your AV receiver has this type of input, make sure it is

connected to your HD DVD player and that the input is set to use

audio from HDMI (and not the SPDIF coaxial or optical input). If your

AV receiver does not have an HDMI input, then the next best choice

is to use the SPDIF (coaxial or optical) input on your AV receiver.

• If you use the SPDIF optical output or analog outputs to connect

your audio system and have the "Digital Out HDMI" (

to "Auto" or "PCM", the audio output level from these jacks will be

reduced when listening to a multichannel disc. To restore the audio

output level, set "Digital Out HDMI" to "Downmixed PCM".

This connection only sends video signals. Be sure to make audio

connection on

480i output only regardless of the resolution settings (

or the connections of other output jack.

This connection only sends video signals. Be sure to make audio

connection on

page 16.

page 21) set

page 20)

7 . 8 . 2

4 : 3 9 : 5 9 P M