Radio Reception
Tuning to radio stations
1
Press SOURCE repeatedly (or TUNER on the
remote control) to select the tuner source (FM
or AM).
2
5 /6
Hold
/
(or
S
T
control) and then release the button.
➜
The system will start searching for a radio
station with sufficient signal strength.
3
Repeat step 3 if necessary until you find the
desired station.
●
To tune to a weak station, press
5 /6
on the remote control) briefly and
repeatedly until you have found optimal
reception.
20
pg001-034_BTM630_37-Eng
Programming radio stations
You can store up to a total of 40 radio stations
(30 for FM and 10 for AM) in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press ALBUM • PRESET +/- (or ¡ / ™ on
the remote control) to select the preset number
where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROG for more than two seconds to
activate programming.
➜
Manual programming
1
Tune to your desired station (refer to "Tuning to
radio stations").
2
Press PROG to activate programming.
➜
3
Press ALBUM • PRESET +/- (or 3 / 4 on
the remote control) to allocate a number from 1
to 40 to this station.
4
Press PROG again to confirm the setting.
➜
the frequency of the preset station are shown.
on the remote
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.
/
(or
S
T
20
All available stations are programmed.
PROG flashes in the display.
PROG disappears, the preset number and
2007.6.14, 17:15
페이지 인쇄