Toshiba SD3010KB 소유자 매뉴얼 - 페이지 21

{카테고리_이름} Toshiba SD3010KB에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba SD3010KB 26 페이지. Upscaling dvd player
Toshiba SD3010KB에 대해서도 마찬가지입니다: 소유자 매뉴얼 (26 페이지)

페이지 인쇄

{ On }

Select this to set low volume output. This feature

is only available for movie discs with Dolby Digital

mode.

Use  /  to select a setting and press OK to

confirm.

Down Sampling

You can enable and disable the digital signal for

better sound output quality.

In ＇Audio＇, press  /  to select { Down

Sampling }, then press .

{ Off }

If your amplifier / decoder is compatible with 96 KHz

PCM, select " Off " . Sound is sampled at 96 KHz.

{ On }

If your amplifier / decoder is not compatible with 96

KHz PCM, select " On " . Sound recorded at 96 KHz

is down sampled to 48 KHz.

Use  /  to select a setting and press OK to

confirm.

Tip:

- When playing back disc with copyright protection,

the sound will be down sampled to 48 KHz even

when you select Down Sampling off.

3D Effects

To obtain expansive virtual surround sound effects

from two speakers, set 3D Effects to on. This

enhancement sounds only output from the Analogue

AUDIO OUT (L / R) jacks of the DVD player.

In 'Audio', press  /  to select { 3D Effects }, then

press .You can set to { Off } or { On }.

Use  /  to select a setting and press OK to

confirm.

Tip:

- Only effective in playback of a DVD Video disc with

Dolby Digital 5.1 bitstream.

Using the Rating setup menu

Press SETUP on the remote control.

The system setup menu appears.

Parental control

: 8.Adult

Language

Set Password

Video

Audio

Rating

Misc

Press  /  to select {Rating }, then press .

Press  /  to select an item, then press  to

access.

Example: { Parental control }

The options for the selected item appears.

If the selection in the menu is greyed out, that

means the feature is not available or not possible to

change at the current state.

Use  /  to select a setting and press OK to

confirm.

Example: { 8. Adult }

The setting is selected and setup is completed.

Helpful hint: Press  to go back to previous menu item.

Press SETUP to exit the menu item.

DVD Menu Options

To exit, press SETUP.

Rating Level settings

Depending on the DVD, you may be asked to

change the parental level while playing the disc. The

rating levels are from 1 to 8 and are country

dependent. You can prohibit the playing of certain

discs that are not suitable for your children, or have

certain discs played with alternative scenes.

In ' Rating ', press  /  to select {Parental control },

then press .

Use the number buttons to enter the four-digit

password, then press OK.(See 'Changing the

Password' on this page)

Press OK again to list the parental level.

{ 1.Kid Safe }

Suitable for children.

{ 2. G }

General Audience; recommended as acceptable for

viewers of all ages.

{ 3. PG }

Parental Guidance suggested.

{ 4. PG-13 }

Unsuitable for children under 13.

{ 5. PG-R }

Parental Guidance Recommended.

{ 6. R }

Restricted; under 17 requires accompanying parent

or adult guardian.

{ 7. NC-17 }

No one under 17 admitted.

{ 8. Adult }

DVD softwares of any grades (adult/general/children)

can be played back. Should be viewed only by adults

due to graphic sexual material, violence or language.

Use  /  to select a rating level and press OK to

confirm.

Select { 8.Adult } to disable parental level and

allow all discs to play.

DVDs that are rated higher than the level you

selected will not play unless you enter your four-digit

password.

Tips:

-This feature will not limit viewing if the disc

manufacturer did not code the disc.

-VCD, SVCD, CD have no level indication, so

parental control has no effect on these type of discs.

This also applies to most illegal DVDs.

-Some DVDs are not coded with a rating though the

movie rating may be printed on the disc cover. The

rating level feature does not prohibit play of such

discs.

Changing the Password

You need to enter your four-digit password to play a

prohibited disc or if prompted for a password.

In 'Rating' , press  /  to select {Set Password },

then press OK.

You will be prompted to enter your four-digit

password.

Enter Password

Use the number buttons ( 0-9 ) to enter the four-digit

password, then press OK.