Toshiba DP-SW25T 소유자 매뉴얼 - 페이지 26
{카테고리_이름} Toshiba DP-SW25T에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba DP-SW25T 37 페이지. Data projector (svga / with pc card slot)
페이지 인쇄
Using the Wireless Utility
■ Displaying a computer's screen via the projector
1
Launch the Wireless Utility
software application.
When the Wireless Utility launches, the Screen
Image transmission mode window appears on
the computer screen.
To switch to the Screen Image transmission
mode window from another mode (File or
Projector Camera), click on the Screen Image
icon
.
2
Select Transmission mode.
Click on Update automatically or Update manually. See step
Update automatically and Update manually.
3
Click on the Advanced button.
The Screen Image: Advanced Settings dialog
appears. Set the dialog as shown below, as
necessary.
• Interruption
Check the No Interruptions checkbox to prevent
other computers from interrupting the projector, for
example, during presentation in the Update
automatically mode.
• Window
Select the Place in Tasktray at the start of
transmission checkbox to iconify the Wireless
Utility and place it in the computer's tasktray
when transmission initiated.
To display the window, double click on this icon, or
right click and select Open from the popup menu.
Even with the Wireless Utility window minimized,
you can use the pop-up menu to stop or resume
transmission as described in step
4
• Mode
Selecting High quality improves the quality of the
projected image, but lowers communication
speed. Selecting High speed has the opposite
effect.
6
for the meanings of
and later
50
4
Select the screen image you wish
the projector to display.
Select Desktop
The computer screen image is transmitted as-is.
Select application window
Select a running application (e.g. Microsoft
®
PowerPoint
), and send that application's
window only.
The desktop and a list of running applications are displayed.
Select the desired application from this list. (If the desired
application is not on the list, launch it. Note that if too many
applications are running, it will consume the computer's
resources, which could slow communication speed.)
5
Select the projector to be
transmitted.
The IDs of projectors accessible for communication
will be listed. (When a projector name is set, that
name appears instead of MAC address.) Select the
checkbox of the projector you wish to transmit to
from this list. Then icon
is displayed on the
projector's screen for few seconds.
It is possible to select up-to four projectors.
6
Click on the
button.
When "Update automatically" is selected in step
Screen images are sent consecutively after the
When "Update manually" is selected in step
A single screen image is sent when the
7
To halt transmission from Update automatically, click on the
button.
If the Wireless Utility icon has been placed in the tasktray, double click on the icon to
display the window, then halt transmission, or right click on the icon, and halt transmission.
Notes
• It may not be possible to transmit the images from movie player or other video applications.
• When using "Update automatically", the transmitted image refresh rate depends on the
performance of the computer you are using and the surrounding radio wave environment.
• The projector screen may have a few differences from the computer screen.
• It is not possible to transmit to a projector that is already receiving from another computer.
• If you selected application window in step
image may not be correctly displayed by the projector.
• The projector ID is the MAC address of the wireless LAN PC card inserted into the
projector.
®
2
button is clicked.
2
button is clicked.
4
, if that application is not active (in use), the
51