Toshiba S9 - TDP S9 - DLP Projector 소유자 매뉴얼 - 페이지 34
{카테고리_이름} Toshiba S9 - TDP S9 - DLP Projector에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba S9 - TDP S9 - DLP Projector 43 페이지. Data projector (svga)
페이지 인쇄
Maintenance
About lamp
The product's light source is a mercury lamp that lights at increased internal pressure. Be sure to
fully understand the following characteristics of the lamp and handle it with extreme care.
• The lamp may burst with a loud noise due to impact or deterioration, or fail to light at the expiration
of its life.
• How long it takes before the lamp bursts or the life expires may vary greatly by lamp. Some may
burst shortly after first use.
• Burst is likely to happen if the lamp is used after the replacement period has elapsed.
• When the lamp bursts, the broken pieces of glass may get inside the product or be released
outside from the openings for ventilation.
• When the lamp bursts, a slight amount of mercury gas enclosed in the lamp along with glass dust
may be released from the openings for ventilation.
■ Immediately replace the lamp when LAMP LED lights amber.
• It is recommended to replace the lamp for approximate 2000 hours after use.
• The risk of burst will increase if the lamp is continuously used without being replaced.
• Frequently check the used hours and prepare spares when the replacement time approaches.
(Refer to "Status display".
■ When the lamp is broken
• If glass components, including a lamp and a lens, should break, handle the broken pieces with
care to avoid injury and contact your dealer for repair service.
• In the event of lamp burst, unplug the product from the wall outlet, leave and completely ventilate
the room. Then, thoroughly clean the area around the projector and discard any edible items
placed in that area.
• When the lamp bursts, consult a doctor if glass dust or mercury gas gets into your eyes or you
breathe it.
Lamp replacement
A lamp is consumable supplies. If used for extended periods, images will appear dark, and
the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The
lifetime of the lamp depends on condition of use.) If this happens, replace it with a new one.
WARNING
• If the projector is mounted on the ceiling, it is recommended to use your Toshiba
dealership when the lamp has to be exchanged.
• When replacing, always use lamp "TLPLS9" (sold separately).
CAUTION
• If you have been using the projector, the lamp will be very hot, and may cause burn injuries.
Wait for the lamp to cool (for longer than 1 hour) before replacing it.
• If the lamp should break, please handle with care to avoid injury due to broken pieces and
contact your dealer for repair service.
)
p.37
34