Toshiba TDP-EW25 소유자 매뉴얼 - 페이지 43
{카테고리_이름} Toshiba TDP-EW25에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba TDP-EW25 50 페이지. Extreme short throw projector
Toshiba TDP-EW25에 대해서도 마찬가지입니다: 사양 (2 페이지), 설치 매뉴얼 (6 페이지)
페이지 인쇄
Setting up the projector using a Web browser (Continued)
Details on major items
•
Settings
When Browser authentication has been set to On, access to the setup page requires
the input of the password.
Wireless LAN:
The items displayed on the screen can be set. Entering individual
items and press the Execute button to update their setting.
Wired LAN:
The items displayed on the screen can be set. Entering individual
items and press the Execute button to update their setting.
Control settings: The items displayed on the screen can be set. Entering individual
items and press the Execute button to update their setting.
Slideshow:
The items displayed on the screen can be set. Entering individual
items and press the Execute button to update their setting.
•
Status display
Displays some states of the projector.
Projector:
Displays the contents of status display in the menu.
Network/USB:
Displays the contents of status display of the Network or USB
memory input.
Maintenance:
Describes an error if it occurs, for example, when the lamp has
blown.
Notes
•
Clicking the ? button opens a popup help window.
The security items such as "Remote control" and "Browser authentication" cannot be
•
set.
84
Maintenance
About lamp
The product's light source is a mercury lamp that lights at increased internal pressure. Be
sure to fully understand the following characteristics of the lamp and handle it with extreme
care.
•
The lamp may burst with a loud noise due to impact or deterioration, or fail to light at the
expiration of its life.
•
How long it takes before the lamp bursts or the life expires may vary greatly by lamp.
Some may burst shortly after first use.
•
Burst is likely to happen if the lamp is used after the replacement period has elapsed.
•
When the lamp bursts, the broken pieces of glass may get inside the product or be
released outside from the openings for ventilation.
•
When the lamp bursts, a slight amount of mercury gas enclosed in the lamp along with
glass dust may be released from the openings for ventilation.
Immediately replace the lamp when a sign appears on the
screen.
•
When the replacement time approaches, a message will appear on the screen.
•
The risk of burst will increase if the lamp is continuously used without being replaced.
•
Frequently check the used hours and prepare spares when the replacement time
approaches. (Refer to "Status display".
When the lamp is broken
•
If glass components, including a lamp and a lens, should break, handle the broken
pieces with care to avoid injury and contact your dealer for repair service.
•
In the event of lamp burst, unplug the product from the wall outlet, leave and completely
ventilate the room. Then, thoroughly clean the area around the projector and discard
any edible items placed in that area.
•
When the lamp bursts, consult a doctor if glass dust or mercury gas gets into your eyes
or you breathe it.
)
p.45
85