Toshiba TDP-EX20U - Short Throw DLP Projector 소유자 매뉴얼 - 페이지 44

{카테고리_이름} Toshiba TDP-EX20U - Short Throw DLP Projector에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba TDP-EX20U - Short Throw DLP Projector 50 페이지. Toshiba tdp-ex20u: specifications
Toshiba TDP-EX20U - Short Throw DLP Projector에 대해서도 마찬가지입니다: 사양 (2 페이지)

페이지 인쇄

Toshiba TDP-EX20U - Short Throw DLP Projector 소유자 매뉴얼

Lamp replacement

A lamp is consumable supplies. If used for extended periods, images will appear dark,

and the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The

lifetime of the lamp depends on condition of use.) If this happens, replace it with a new one.

WARNING

•

If the projector is mounted on the ceiling, it is recommended to use your

Toshiba dealership when the lamp has to be exchanged.

Uncovering the lamp while the projector is mounted on a ceiling may lead to a danger

of damage from falling pieces of glass if the lamp is broken. Besides, working at high

elevations can also be hazardous. Do not attempt to replace the lamp by yourself.

•

When replacing, always use lamp "TLPLW15" (sold separately).

CAUTION

•

If you have been using the projector, the lamp will be very hot, and may cause

burn injuries.

Wait for the lamp to cool (for longer than 1 hour) before replacing it.

•

If the lamp should break, please handle with care to avoid injury due to broken

pieces and contact your dealer for repair service.

Unplug power cord.

Wait until lamp is sufﬁciently cooled.

Wait for at least 1 hour.

Remove the outer lamp cover.

Loosen the 2 screws, raise the outer lamp cover

with your ﬁngers as shown to remove the outer

lamp cover. Use care to avoid any damage to nails

and/or tip of your ﬁnger(s). If you have any difﬁculty

in removal, you can use a screwdriver or any other

smaller tool for your convenience.

Outer lamp cover

Remove the inner lamp cover.

Loosen the screw to remove the inner lamp cover.

Pull out the lamp.

Loosen the 3 lamp locking screws, pull up the

handle, and press the tab to remove the lamp.

Mount the new lamp.

Align the orientation, press down the new lamp until

the bottom is reached, and lock in place using the 3

lamp locking screws.

Replace the inner lamp cover.

Tighten the screw loosened in step

inner lamp cover is no longer loose.

Replace the outer lamp cover.

Align the cover, and press it in, then tighten the

screws loosened in step

until the outer lamp

cover is no longer loose. (Be sure to replace the

outer lamp cover.)

Reset the lamp time.

See the lamp's manual for instructions on resetting

the lamp time.

Inner lamp cover

Tab

until the