Toshiba TDP-MT200 소유자 매뉴얼 - 페이지 20
{카테고리_이름} Toshiba TDP-MT200에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba TDP-MT200 44 페이지. Dlp projector
Toshiba TDP-MT200에 대해서도 마찬가지입니다: 소유자 매뉴얼 (46 페이지)
페이지 인쇄
Connection
Before connection
• Read the owner's manual of the device you are connecting to the projector.
• Some types of computer cannot be used or connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connecting.
• The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
Computer (for control)
To RS-232C
p.43
terminal
Control cable
DVD video recorder, etc.
Notes
• If you want to feed the digital RGB signal, separately available DVI cable is needed.
• If you are using the digital RGB signal for input to this unit, some computer models or a
certain type of DVI cable may cause on rare occasions noise on the screen. If such is a
case, decrease your computer's refresh rate or the resolution. It is also recommended to
use a DVI cable in 2 m or less in length.
Video recorder,
DVD player, etc.
To S-Video
output
S-Video cable
(supplied)
RGB component video cable
(not supplied)
To Y/C
/C
output
B
R
Green (Y)/Blue (C
)/Red (C
)
B
R
Computer
20
, etc.
p.39
VCR, etc
To video
output
Video cable (supplied)
DVI cable
(not supplied)
RGB cable
(not supplied)
To RGB output
To DVI output
Computer