Toshiba TDP-MT700 서비스 매뉴얼 - 페이지 16
{카테고리_이름} Toshiba TDP-MT700에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba TDP-MT700 49 페이지. Home theater projector
Toshiba TDP-MT700에 대해서도 마찬가지입니다: 소유자 매뉴얼 (34 페이지), 소유자 매뉴얼 (36 페이지)
페이지 인쇄
MT700 Service Manual
The DAD1000 will generate DMD reset signals MBRST[0..15] as well as
VCC2 (7.5V) for DMD chip.
4. Motor Controller SH6742:
The DDP1010 electronics support driving three phase, 12 poles, Y
configuration, brushless DC color wheel motor. The DDP1010 electronics
use a combination of back EMF from motor and the CWINDEX signal to
frequency and phase lock the color wheel revolution to 2.5 times of VSYNCZ
rate.
4.1.2.1. Fan control
In this projector, there are four fans for cooling the system.
i.
Fan 1 (Main Fan): for cooling the lamp, light pipe and color wheel
ii.
Fan 2 (Blower): for cooling the lamp,
iii.
Fan 3 (Power Fan): for cooling the power module and ballast
iv.
Fan 4 (DMD Fan): for cooling the DMD chip
1. Fan controller MAX6660:
The four fan controllers are used for controlling the four fans independently.
Each fan has a FANSPIN output to each fan controller. The fan controller
can use this signal to detect if the fan is spinning or not. If the fan stops, the
CPU will turn off the DMD RESETZ and PWRGOOD signals, then the DMD
system and Lamp will be turned off.
2. Thermal sensor on lamp box:
The thermal sensor on the lamp box is used for detecting temperature
around the Lamp box.
3. Intake thermal sensor:
The intake thermal sensor will sense the intake temperature. The CPU will
read temperature from the fan controller. The CPU will compare temperature
of lamp box sensor and temperature of intake sensor, then control the speed
of fans. If temperature is out of limit, the CPU will turn off the projector
system.
15