Toshiba TDP-T40U 소유자 매뉴얼 - 페이지 12
{카테고리_이름} Toshiba TDP-T40U에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba TDP-T40U 23 페이지. Projector
Toshiba TDP-T40U에 대해서도 마찬가지입니다: 사양 (1 페이지), 사양 (2 페이지)
페이지 인쇄
Connection
Before connection
• Read the owner's manual of the device you are connecting to the projector.
• Some types of computer cannot be used or connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connecting.
• The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
Audio amplifier, etc.
To audio input
To RS-232C terminal
White (L)/Red (R)
Audio cable
(not supplied)
RGB cable
(not supplied)
To RGB
output
Audio cable
(not supplied)
To audio
output
Computer
Computer
Notes
• COMPUTER terminals 1 and 2 function identically.
• The AUDIO IN terminal doubles for devices connected to COMPUTER terminals 1 and 2.
p.41
, etc.
Computer
(for control)
Video recorder,
DVD player, etc.
To audio output
To S-Video
p.43
White (L)/Red (R)
output
Video cable
Control cable
(not supplied)
CONTROL
S-VIDEO
MONITOR
AUDIO OUT
R
L
VIDEO
COMPUTER 2 IN
COMPUTER 1 IN
(
Y/P
/P
)
AUDIO IN
(
Y/P
/P
)
B
R
B
R
AV cable
To audio
(not supplied)
output
White (L)/
Red (R)
Audio cable
(not supplied)
RGB cable
VCR
To audio
(supplied)
Monitor cable Mini D-sub
output
To RGB
15P-BNC
output
(not supplied)
To Y/C
/C
output
B
R
Green (Y)/Blue (C
)/Red (C
B
Conversion adapter BNC-pin
(not supplied)
DVD video recorder, etc.
22
Operations
Turning the power on and off
Connecting the power cord
1
Insert the power cord connector into the
AC IN socket of the projector.
2
Insert the power cord plug into a wall or
other power outlet.
Removing the lens cover
Turning the power on
S-Video cable
1
Turn on the main power switch
(not supplied)
The ON indicator will change to
orange, indicating standby mode.
2
Press the ON/STANDBY
button.
The power turns on, and the following
3 green indicators light: ON, LAMP,
and FAN. After a moment, the start-up
screen appears.
To video
output
CAUTION
• Do not look into the lens while the lamp is on. The strong light from the lamp may cause
)
R
damage to your eyes or sight.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.
• Do not place your hands, face, or other objects near the air exhaust. Doing so could cause
burns, deform/break the object.
(Supplied) Power cord connector
Be sure to remove the lens cover when the power is
turned on. If it is left on, it could become deformed due
to heat.
LAMP
(Orange)
Remote
Control panel
Control
Start-up screen
23
TEMP
FAN