Philips FW P88 사용자 설명서 - 페이지 20
{카테고리_이름} Philips FW P88에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Philips FW P88 31 페이지. Mini hi-fi system with 3 cd changer
Philips FW P88에 대해서도 마찬가지입니다: 사용자 설명서 (30 페이지), 사용자 설명서 (31 페이지), 사양 (2 페이지), 사양 (2 페이지), 매뉴얼 (32 페이지), 매뉴얼 (31 페이지)
페이지 인쇄
TUNER
MINI HIFI SYSTEM
STANDBY
ON
POWER SAVE
IR SENSOR
CD 1•2•3
BAND
C 1 • 2 • 3
BAND
CD
TUNER
SEARCH•TUNING
STOP•CLEAR
CLOCK/
PROG
TIMER
BASS
PLUS
Note:
– For 'EASY SET' feature, please refer to
page 13.
Tuning to radio stations
1 Press TUNER (BAND) to select TUNER
mode.
™ "TUNER" will be displayed.
A few seconds later, the current radio
frequency will be displayed.
2 Press TUNER (BAND) again to select
the desired waveband : FM, MW or LW.
3 Press à or á for more than one
second, then release.
™ The display will show "SEARCH"
until a radio station with sufficient
signal strength is found.
20
pg 01-31/P88/22-Eng
20
DOLBY B NR
LEFT
CENTER
RIGHT
NEWS/TA
SURR
SURR
PRO LOGIC
RDS
TAPE 1•2
CDR/DVD
CD TEXT
CDR
TAPE
AUX
PRESET
PLAY PAUSE
PREV
SIDE
NEXT
DUB
DIM
A. REV
RECORD
(HSD)
TREBLE
wOOx
TECHNOLOGY
LEVEL
• Repeat this procedure until the desired
station is reached.
• To tune to a weak station, briefly press
à or á repeatedly until the display
shows the desired frequency and/or
when the best reception has been
obtained.
Storing Preset Stations
You can store up to 40 radio stations in the
memory. When a preset radio station is
selected, the preset number appears next
to the frequency on the display.
Automatic programming
1 Press TUNER (BAND).
2 Press PROG for more than one second.
™ The
starts flashing and
PROGRAM
"AUTO" will be displayed.
™ The system will start searching for all
radio stations with RDS and then
followed by radio stations on FM,
MW and LW band respectively.
™ All available stations will be stored
automatically. The frequency and
preset number will be displayed
briefly.
™ The system will stop searching when
all the available radio stations are
stored or when the memory for 40
preset radio stations is used.
™ The system will remain tuned to the
last stored preset radio station.
Notes:
– You can cancel the automatic
programming by pressing PROG or Ç
(on the system only).
– If you want to reserve a section of
preset numbers, for example preset
numbers 1 to 9, select preset 10 before
starting automatic programming, only
the preset numbers 10 to 40 will be
programmed.
Manual programming
1 Press TUNER (BAND).
2 Press TUNER (BAND) again to select
the desired waveband : FM, MW or LW.
3 Press PROG for less than one second.
™ The
starts flashing.
PROGRAM
™ The next available preset number will
be displayed for selection.
3/6/00, 1:27 PM
4 Press à or á to tune to the desired
frequency.
• If you wish to store the radio station to
another preset number, press 4 or 3
(or Digit 0-9 on the remote control) to
select the desired preset number.
5 Press PROG again.
™ The
disappears and the
PROGRAM
radio station will be stored.
• Repeat steps 3 – 5 to store other preset
radio stations.
Notes:
– When 40 radio stations are stored and
you attempt to store another radio
station, the display will show
" PROGRAM FULL ". If you want to
change an existing preset number,
repeat steps 3 – 5.
– You can cancel manual programming by
pressing Ç (on the system only).
– During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
Tuning to Preset Radio
Stations
• Press 4 or 3 (or Digit 0-9 on the
remote control) to select the desired
preset number.
™ The preset number, radio frequency,
and waveband appear on the display.
3139 116 19721