Toshiba TDP-WX5400U 소유자 매뉴얼 - 페이지 37

{카테고리_이름} Toshiba TDP-WX5400U에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba TDP-WX5400U 42 페이지. Toshiba tdp-wx5400: user guide
Toshiba TDP-WX5400U에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)

페이지 인쇄

Replacing the filters

When the lamps are replaced, the filters should also be replaced, not cleaned.

Refer to the following guide to replace the filters.

CAUTION

•

Do not drop the projector on your hand or fingers while lifting the projector to

replace the filters. Doing so could injure your hand or fingers.

Note

•

The side and the rear filters can be pulled out from

the slots located at the bottom as shown.

Gently slide the filter holders in the direction

shown.

Lift the filter foams from all three filter

holders in the direction shown.

Remove them completely from each filter

holder and discard.

Place a replacement foam and press down

firmly.

Replace the filter holders by pushing gently

in the direction shown.

Note

•

When dirt and dust build up in the filter, the air circulation inside the projector is

affected and the internal temperature will rise, causing the projector to stop working or

malfunction.

•

Be sure the filter is inserted all the way into the slot. Leaving gaps will allow dust and

dirt to get inside the projector again.

•

When you purchase a new lamp, new filters are also provided. If a filter is torn or dirty,

please replace with new one. Continuing to use a ripped filter will allow dust and dirt to

get inside the projector.

•

Never run the projector with the filters removed. It is recommended that you clean the

Bottom

Resetting the filter time counter



After replacing the filters, the filter time counter should be reset to zero. Refer to the

following guide:

Press the MENU button on the control panel or remote to open the Main menu.

Press the p or q button to move to the [Reset] menu and press Enter.

The [Reset] menu is displayed.

Select [Clear filter time] using p or q and press Enter.

A confirmation box is displayed.

Select OK using t or u and press Enter to reset the filter time to zero.