Philips FW P880 사용자 설명서 - 페이지 28
{카테고리_이름} Philips FW P880에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Philips FW P880 32 페이지. Mini hi-fi system with 3cd changer, 400 watts total power, 5 speaker dolby pro-logic system and woox technology
Philips FW P880에 대해서도 마찬가지입니다: 사양 (2 페이지)
페이지 인쇄
Clock/Timer
2
Press CD, TUNER or TAPE to select the
desired source.
G Make sure the music source has been prepared.
CD – Load the disc(s). To start from a specific
track, make a program (refer to "CD Operation -
Programming the disc tracks").
TUNER – tune to the desired radio station.
TAPE – load the prerecorded tape into tape
deck 2.
3
Press à or á on the system repeatedly to set
the hour for the timer to start.
4
Press í or ë on the system repeatedly to set
the minute for the timer to start.
5
Press CLOCK/TIMER to store the start time.
➜ The timer is now set and activated.
➜
will remain on the display.
TIMER
G At the preset time, the selected source will play.
To exit without storing the setting
G Press Çon the system.
Notes:
– If the selected source (CD) is not available when
preset timer is reached, TUNER will be selected
automatically.
– If the source selected is TAPE, and if the preset
time is reached during dubbing, TUNER will be
selected automatically.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
To deactivate the TIMER
G Press TIMER ON/OFF on the remote control.
➜ The display will show "CANCEL" and
will disappear from the display.
To activate the TIMER
G Press TIMER ON/OFF on the remote control.
➜ The last set timer information will be shown
for a few seconds and
display.
28
pg 001-032/P880/37-Eng
TIMER
will appear on the
TIMER
28
Sleep Timer Setting
The sleep timer enables the system to switch to
Standby mode automatically at a preset time.
1
Set the clock (refer to "Clock Setting").
2
Press SLEEP on the remote control repeatedly
to select a preset time.
➜ The selections are as follows (time in
minutes):
60 ™ 45 ™ 30 ™ 15 ™ OFF ™ 60 ...
➜ "SLEEP XX" or "OFF" will be displayed. "XX"
is the time in minutes.
3
When you reach the desired length of time, stop
pressing the SLEEP button.
➜ The Sleep Timer is now set. After this
amount of time passes, the system will switch to
Standby mode.
To deactivate the Sleep Timer
G Press SLEEP repeatedly until "OFF" is displayed,
or press the STANDBY ON button.
12/8/00, 1:54 PM
3139 115 20421