MSI E7210 Master-FARM 사용자 설명서 - 페이지 27

{카테고리_이름} MSI E7210 Master-FARM에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. MSI E7210 Master-FARM 34 페이지. (v1.x) atx server board

MS-9149 ATX Server Board

this field. With the t hermal monitorin g enabled, clock modulation co ntrolled

by the processor's internal thermal sensor is also activated to keep the proces-

sor within allowable temperature limit. Setting options: 4 Min, 8 Min, 16 Min,

32 Min.

Thermal Management

This feature allows you to specify the thermal monitoring system. Settings are:

Thermal Monitoring 1 on die throttling

Thermal Monitoring 2 Ratio & VID transition

TM2 Bus Ratio (hidden for Prescott processor)

It represents the frequency (bus ratio) of the throttled performance state that

will be initiated when the on die sensor goes from not hot to hot. Key in a DEC

number between 0 and 255.

TM2 Bus VID (hidden for Prescott processor)

It represents the voltage of the throttled performance state that will be initiated

when the on die sensor goes from not hot to hot. Settings range from 0.8375V

to 1.6000V.

3-14

Advanced Chipset Features

NOTE

Change these settings only if you are familiar with the chipset.

DRAM Timing Selectable

Selects whether DRAM timing is controlled by the SPD (Serial Presence Detect)

EEPROM on the DRAM module. Setting to By SPD enables DRAM timing to

be determined automatically by BIOS based on the configurations on the SPD.

Selecting Manual allows users to configure these fields manually.

CAS Latency Time

This controls the timing delay (in clock cycles) before SDRAM starts a read

command after receiving it. Settings: 2, 2.5, 3 (clocks). 2 (clocks) increases

the system performance the most while 3 (clocks) provides the most stable

performance.

Active to Precharge Delay

The field specifies the idle cycles before precharging an idle bank. Settings:

8, 7, 6, 5 (clocks).

DRAM RAS# to CAS# Delay

This field allows you to set the number of cycles for a timing delay between

the CAS and RAS strobe signals, used when DRAM is written to, read from

or refreshed. Fast speed offers faster performance while slow speed offers

more stable performance. Settings: 4, 3, 2 (clocks).

BIOS Setup

3-15