Croydex GP78100 지침 리플렛
{카테고리_이름} Croydex GP78100에 대한 지침 리플렛을 온라인으로 검색하거나 PDF를 다운로드하세요. Croydex GP78100 2 페이지. Bendy rail
페이지 인쇄
SAFETY AND CARE
Always take care when using power tools,
particularly if
there is
any water in the
working area.
Do not use a hammer drill when drilling into a
tiled surface.
Always use a drill bit that is suitable for the
surface that is being drilled.
The wall plugs supplied are for use on solid
walls only. For cavity walls or plasterboard use
specialist fixings that are suitable for the type
of wall construction.
x2
2
x
3
After the rail has been bent, cut the rail ends straight
as shown.
Croydex, Central Way, Andover,
Hampshire, SP10 5AW, UK
To retain the best quality finish, clean product
regularly with a soft damp cloth.
Do not use abrasive or chemical cleaners, as
these will damage the product.
Do not use this product as a grab bar.
If the gliders become sticky, use a small
amount of furniture polish to improve
performance.
Do not overload the rail. Suitable for use with
a maximum of two standard shower curtains.
4
each wall bracket on the
mounting surface. Use
a spirit level to ensure it
+44 (0) 1264 356437
+44 (0) 1264 365881
x2
x1
x1
(2)
Quantities of parts may vary due to product sizes.
1
Remove the end brackets from the Bendy Rail.
5
At this stage, measure the distance between the top
Hold the rail in the
of the wall bracket and the ceiling.
desired position
ensuring there
is adequate
curtain overlap
into the bath
or shower tray.
Mark the position of
is level.
x1 (2)
x12 (24)
x1 (2)
x3
x1
x1 (2)
(2)
(2)
x1
2
Form the Bendy Rail to your desired size and shape.
The minimum bend radius is 150mm.
Once you have bent your rail, DO NOT make
any attempt to undo the bend as this will
separate the rail components and cause the
hooks to fall out.
6
Using this measurement, cut the ceiling support rod
to length for use later.
?
www.croydex.com
x5 (6)
x5 (6)
x1
?
R&R 061 R04