3Com 3CRWEASYG73 - 11g Wireless LAN Outdoor 빠른 시작 매뉴얼 - 페이지 11
{카테고리_이름} 3Com 3CRWEASYG73 - 11g Wireless LAN Outdoor에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 3CRWEASYG73 - 11g Wireless LAN Outdoor 14 페이지. 11g 54mbps wireless lan building-to-building bridge family
3Com 3CRWEASYG73 - 11g Wireless LAN Outdoor에 대해서도 마찬가지입니다: 데이터시트 (4 페이지)
페이지 인쇄
5
Find your New Wireless Bridge
To find your new Wireless Bridge you will need to connect the Wireless Bridge to the same physical LAN network as your
PC. By default, the Wireless Bridge will use DHCP Client mode to get an IP address from a DHCP Server. If your network
does not have a DHCP server, the Bridge uses a default IP address of 169.254.X.Y, where the X and Y is the last two bytes
of the MAC address in decimal value respectively. You can use that default IP address to configure the Wireless Bridge
through a web browser directly.
To find your new Wireless Bridge, open the 3Com Wireless Infrastructure Device Manager (WIDMAN) utility. On start up,
the dialog box will look like the figure below:
Click the 'Refresh' button and the 3Com Wireless Infrastructure Device Manager (WIDMAN) utility will begin to discover
devices. After finding the new Wireless Bridge, it will list it in the list box.
Choose the Wireless Bridge in the list box, and then click the 'Configure...' button. The web browser wills pop-up, and it
will bring you to the WEB UI of the Wireless Bridge.
3Com Corporation
Page 10