3Com 3CRWX275075A - Wireless LAN Managed Access Point 2750 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} 3Com 3CRWX275075A - Wireless LAN Managed Access Point 2750에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 3CRWX275075A - Wireless LAN Managed Access Point 2750 14 페이지. Ap2750 managed access point
3Com 3CRWX275075A - Wireless LAN Managed Access Point 2750에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (9 페이지), 빠른 시작 매뉴얼 (17 페이지)
페이지 인쇄
3Com AP2750 Managed Access Point Features
Power Port
Serial Port
Ethernet Port
Feature
Power Port
Serial Port
Ethernet Port
LEDs
Antenna Connectors
Reset Button
Mounting Bracket
LEDs
Mounting
Bracket
Description
The access point can be powered either via Power Over Ethernet (PoE), or by an
external power supply (not included) that is plugged into the Power Port.
The serial port is not supported.
The Ethernet port provides a 10/100BASE-TX Ethernet connection to a 3Com Wireless
LAN switch. The connection can be direct to a 3Com switch or indirect through an
intermediate Layer 2 or Layer 3 network.
Use a standard Category 5 cable with straight-through signaling and standard RJ-45
connectors to connect the access point to the switch on the network.
The LEDs indicate power and activity. See "Checking the LED Indicators" on page 7
for details.
Two SMA-female antenna connectors allow you to connect antennas that operate in
2.4 GHz and 5.3 GHz bands.
The reset button is accessible from the back of the access point as well as through the
mounting bracket. Push the reset button to restore the access point to its factory
default settings.
The mounting bracket comes attached to the access point. This mounting bracket
allows the access point to be mounted to a wall or ceiling.
2
Antenna
Connectors
Reset
Button