Dimplex CXL12N 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Dimplex CXL12N에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex CXL12N 8 페이지. Ultra-slim storage and convector heaters
Dimplex CXL12N에 대해서도 마찬가지입니다: 운영 매뉴얼 (5 페이지), 설치 지침 매뉴얼 (8 페이지), 사용 설명서 및 소유자 매뉴얼 (5 페이지)

페이지 인쇄

25. Replace the element which had been removed by carefully passing

the ends through the base insulation slots into the terminal blocks below.

Position the insulator on the element end in contact with the terminal block

ceramic as shown, and tighten the connection screws. At this point check

that all element connections are tight.

27. Re-ﬁ t the front panel/insulation assembly, ensuring the bottom edge

of the panel is located behind the base ﬂ ange.

29. Replace the spacer nut, washer and screw removed in 18 and reconnect

the two quick connect terminals removed in 19.

26. Fit the front bricks with the airways facing inwards

28. Make sure all screws removed in operation 20 are replaced

securely.

30. Connect the off peak supply to the storage terminal block at the right

side of the base panel.

Replace the convector terminal block and insulation card at the left side

of the base panel, clip wires running across heater and connect peak

supply.

HEAT RESISTING CABLE MUST BE USED.

NOTE: ON NO ACCOUNT SHOULD SURPLUS CABLE BE STUFFED

INSIDE THE HEATER.

WARNING: THIS APPLIANCE MUST BE EARTHED . CHECK ALL

ELECTRICAL CONNECTIONS FOR TIGHTNESS.