AEO WP40SP10 사용자 설명서

{카테고리_이름} AEO WP40SP10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEO WP40SP10 2 페이지. 10w solar panel & dc water pump kit

 Place the Water Pump under water BEFORE connecting to a power source.

 The water pump may become damaged if it is not under water before powering it on.

 The plugs on the power cable connected to the Solar Panel (1) and power cable connected to the Water

Pump (2) must match in polarity (+ -). Connect the two plugs by matching the flat sides.

Section 2.)

 This is a DC (Direct Current) water pump. DO NOT connect to any AC power.

 The performance of the pump depends on sunlight intensity and the angle at which sunlight strikes the

solar panel surface. For safety purposes, the Solar Panel is at recommended 18V, because a 24V solar

panel actual output will exceeds its nominal voltage when sunlight at highest intensity.

 Please carefully read this user manual before installing the pump.

Section 1: INCLUDED

(1) Solar Panel

(2) Water Pump

(3) Ground Spike

(4) Nozzle Kit

Section 2: CAUTIONS

Make sure the water pump is fully submerged underwater while it is operating.

Do not connect the pump to any AC power supply; it is designed ONLY for DC power. The Solar Panel included is 18V

because the output is usually greater.

The polarity of the power cable plug on the Water Pump (2) must match the plug

on the Solar Panel (1) as shown in the figure to the right. Connect the two plugs by

matching the flat sides; do not force them together.

Any alteration of the product itself or changing of the components voids

warranty.

Operate the pump in water only (under 104°F), and keep it away from

flammable liquids.

Do not let the pump run dry; it does not have dry-run protection.

Section 3: ASSEMBLY

*Unpack all components carefully.

1. [Setup Water Pump]

Connect the nozzles tubes (adjust the height by the number of tubes) to the water pump outlet to produce

AEO-WP40SP10-KIT

10W SOLAR PANEL & DC WATER PUMP KIT

USER MANUAL

(See fig. 2.3 in