3Com 8700 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} 3Com 8700에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 8700 10 페이지. Wireless lan access point
3Com 8700에 대해서도 마찬가지입니다: 데이터시트 (4 페이지)

09-2292-00AC.fm Page 3 Tuesday, March 11, 2003 3:53 PM

CAUTION: Do not handle the antenna tips, especially after they are connected to the access

point, as this could lead to electrostatic discharge (ESD), which could damage

the equipment.

The installation CD includes the User Guide, which contains more detailed information on planning,

installing and conﬁguring the device. Additional tools and utilities are provided to assist with the

management of your network. See "Documentation and Software Utilities" on page 7 for instructions.

Connect the Power

The access point complies with the IEEE 802.3af power-over-Ethernet standard. It receives power over a

standard category 5 straight (8-wire) Ethernet cable. There are two ways to supply power to the access

point (refer to the illustration below):

Use the supplied 3Com Integrated Power-over-Ethernet power supply. In this case,

you need to supply a second Ethernet cable to connect to the wired LAN.

Connect the access point directly to your own power-over-Ethernet hub or switch, which

must also comply with the IEEE 802.3af standard.

"To Access Point"

The power supply can be located at any point between the access point and the LAN access port,

wherever a convenient power outlet exists. If you supply your own Ethernet cable for connecting power,

be sure that it is standard category 5 straight-through (8-wire) cable that has not been altered in any

way. Use of nonstandard cable could damage the access point.

Refer to the illustration above, and follow these steps:

Connect one end of the Ethernet cable to the Ethernet port on the access point.

Connect the other end of the Ethernet cable to the port labeled To Access Point on

the power supply.

Connect the power cord to the power supply and plug the cord into a power outlet.

"To Hub/Switch"

Using A Power-over-Ethernet

LAN Port