CRS 5AHPR0 운영 매뉴얼 - 페이지 7

{카테고리_이름} CRS 5AHPR0에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CRS 5AHPR0 9 페이지. Electronic crimping tool hps with external activation

PROGRAMNOx

Sets the program to one of the preset programs, 0-

TARGETxx

Sets the Stop Position as a % of maximum, or if xx

is omitted requests the stop position.

CRIMP

Executes the crimping (or decapping) cycle

Demonstration Interface

A simple C# program is available to test the crimper interface and to aid in development.

This program can be downloaded from:

https://www.ChromRes.com/media/catalog/product/5/A/HPR%20Demonstration.zip

Electronic Crimping Tool 5AHPR0

Instructions:

1. Connect the RS485 port on the crimper to a serial

port of the crimper. (It might be helpful to use a USB <=>

RS485 converter, such as the B&B Electronics

USPTL4).

2. Start the demonstration program, select the correct

COM port and click the "Connect" button.

3. The log window should start to show the

communications between the crimper and the computer.

4. The various commands and the available can be

tested using the buttons.

The log window shows the communication between

the tool and the test program. Note that the program

queries the tool setting continuously to keep up with any

manual changes to the tool settings, with a lag time of

several seconds.