CRT S 8040 소유자 매뉴얼 - 페이지 13

{카테고리_이름} CRT S 8040에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CRT S 8040 18 페이지. Mobile cb transceiver

6) AM/FM

Modulation Mode selection: This key (6) [AM/FM] allows selecting the AM or FM modula-

tion. Your modulation mode has to correspond to the one of your correspondent.

With the version Full Multi Norm in the norm UK, your can switch between the EU band

and the UK band, which is indicated by symbol "EU" or "UK", by pressing the key (6)

[AM/FM ]. The CB band EU consists of the 40 CEPT channels.

The CB band UK consists of 40 channels starting from 27.60. 25 MHz to 27.99. 25 MHz.

7) CH9/19

It contains the priority channels 9 and . 9, press the key (7) [CH9/. 9] once to select priority

channel 9, press the key (7) [CH9/. 9] again to set priority channel . 9.

8) [ √ ] key (DN key on the microphone)

Channel down; selected channel downward.

9) [ ] key (UP key on the microphone)

Channel up; selected channel upward.

All channels can be selected by channel selector keys (8) or (9). The selected channel is

displayed on the LCD. In communication both transceivers (the receiving and transmitting

party) need to be in the same channel and under same modulation type.

. 0) SCAN

Press the key (. 0) [SCAN] to enable the SCAN function. Before enabling the SCAN

function, firstly turn the SQ control clockwise till the background noise is cut out.

Then press the key (. 0) [SCAN], radio will automatically scan all channels and the SC icon

will appear on the LCD.

When a signal is detected on a channel, scanning stops on this channel. You can receive

the calling, and also, can transmit on this channel by pressing PTT key. If there is no trans-

mission or detected signal on that channel within 5 seconds, radio will start scanning

again. To exit the SCAN function, press the SC key or the PTT key.

. . ) PTT (on the microphone)

To transmit, press and hold the key (. . ) [PTT] and the TX icon will appears on the LCD.

For best quality, please speak normally at a distance of 2 - 4 inches.

Speaking too loudly will cause distortions and make the signal difficult to understand.

On completion of the transmission release the PTT key and the radio will revert to

receiving mode.